3 Configuring xorg.conf for desktop effects

Before you install and run Compiz Fusion, you need to add a few settings to /etc/X11/xorg.conf:

Add the following section to enable composite effects:

Section "Extensions"
Option         "Composite" "Enable"

Locate the “Screen” section which should look similar to the one below:

Section "Screen"
Identifier     "Screen0"
Device         "Card0"
Monitor        "Monitor0"

and add the following two lines (after “Monitor” will do):

DefaultDepth    24
Option         "AddARGBGLXVisuals" "True"

Locate the “Subsection” that refers to the screen resolution that you wish to use. For example, if you wish to use 1280x1024, locate the section that follows. If the desired resolution does not appear in any subsection, you may add the relevant entry by hand:

SubSection     "Display"
Viewport    0 0
Modes      "1280x1024"

A color depth of 24 bits is needed for desktop composition, change the above subsection to:

SubSection     "Display"
Viewport    0 0
Depth       24
Modes      "1280x1024"

Finally, confirm that the “glx” and “extmod” modules are loaded in the “Module” section:

Section "Module"
Load           "extmod"
Load           "glx"

Note: If you installed the x11/nvidia-xconfig port, you should be able to perform most of the above settings by entering the following commands (as root):

# nvidia-xconfig --add-argb-glx-visuals
# nvidia-xconfig --composite
# nvidia-xconfig --depth=24

You may wish to run nvidia-xconfig -A | more to see a list of all the options offered by the above program.

This, and other documents, can be downloaded from ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/.

For questions about FreeBSD, read the documentation before contacting <questions@FreeBSD.org>.
For questions about this documentation, e-mail <doc@FreeBSD.org>.