Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 17 Nov 2000 10:38:51 -0800 (PST)
From:      joseph@randomnetworks.com
To:        stable@freebsd.org
Subject:   4.2 Beta hang on warm boot
Message-ID:  <Pine.BSF.4.21.0011171031350.1026-100000@rodan.water-programs.com>

next in thread | raw e-mail | index | archive | help

	I dug up an old 486 in hopes that I could get 4.2-BETA from 11/15
to install on it and use it as a firewall for my cable connection at
home.  Everything went nicely until that first reboot after the
install.  It hung when it hit the ISA bus.  I thought this was odd, so I
turned off the power and then fired it back up.  It then booted fine.  So
I did a shutdown -r now to see what would happen.  It hung on the ISA bus
during boot again.  Once again I turned off the power and it booted fine
after powering it back on.

	So from this, 4.2-BETA from 11/15 will not warm boot (reboot),
stopping on the ISA bus.  I've attached the dmesg output from a cold boot
and marked the line that it stops at during a warm boot.

	Any ideas on what's happening here?

--------------------------------------------------------------------
| Joseph Scott                       The Office Of Water Programs  |
| joseph@randomnetworks.com          joseph.scott@owp.csus.edu     |
--------------------------------------------------------------------

Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.2-20001115-BETA #0: Wed Nov 15 12:57:10 GMT 2000
    root@usw3.freebsd.org:/usr/src/sys/compile/GENERIC
Timecounter "i8254"  frequency 1193182 Hz
CPU: i486 DX2 (486-class CPU)
  Origin = "GenuineIntel"  Id = 0x435  Stepping = 5
  Features=0x3<FPU,VME>
real memory  = 25427968 (24832K bytes)
config> di psm0
config> di sn0
config> di lnc0
config> di ie0
config> di fe0
config> di cs0
config> di bt0
config> di aic0
config> di aha0
config> di adv0
config> en ed0
config> po ed0 0x300
config> ir ed0 5
config> iom ed0 0xd8000
config> f ed0 0
config> q
avail memory = 20652032 (20168K bytes)
Preloaded elf kernel "kernel" at 0xc0436000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc043609c.
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
isa0: <ISA bus> on motherboard ********* !! Dies here on warm boot !! **
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
ata0: mask=03 status0=50 status1=00
ata0: mask=03 ostat0=50 ostat2=00
ata0-master: ATAPI probe a=00 b=00
ata0-slave: ATAPI probe a=00 b=00
ata0: mask=03 status0=50 status1=00
ata0-master: ATA probe a=01 b=a5
ata0: devices=01
ata0 at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0
ata1: mask=00 status0=ff status1=ff
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: cannot reserve I/O port range
ed0 at port 0x300-0x31f iomem 0xd8000 irq 5 drq 0 on isa0
ed0: address 00:c0:f0:09:eb:b6, type NE2000 (16 bit) 
ad0: 325MB <QUANTUM LPS340A> [1011/15/44] at ata0-master BIOSPIO
Mounting root from ufs:/dev/ad0s1a




To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.21.0011171031350.1026-100000>