Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 15 Aug 2009 18:02:11 +0000
From:      "b. f." <bf1783@googlemail.com>
To:        fernando.apesteguia@gmail.com
Cc:        freebsd-questions@FreeBSD.org
Subject:   Re: 7.2 burncd and cdrecord problem
Message-ID:  <d873d5be0908151102n5bafe979sa1ccf42654600909@mail.gmail.com>

next in thread | raw e-mail | index | archive | help
> I'm trying to get my CD drive to work without so much success.
> Reading is fine, but when I try to burn a CD I get errors in dmesg.

>Using cdrecord -blank=fast dev=3,0,0 I get:

First, I hope that you are using sysutils/cdrtools-devel rather than
sysutils/cdrtools.  The latter is several years out of date, and the
upstream maintainer of the software has said that no one should be
using it, but the maintainer of the FreeBSD port has so far been
unwilling to update it.

...

>And dmesg shows:
>acd0: FAILURE - READ_BUFFER ILLEGAL REQUEST asc=0x24 ascq=0x00
>acd0: FAILURE - MODE_SELECT_BIG ILLEGAL REQUEST asc=0x26 ascq=0x00

It is not unusual for some errors to appear, even during normal
operation, so these don't necessarily indicate a problem, although it
was good that you posted them.  You should run the cdrecord command
with -vv (yes, two v's) to get verbose error messages from cdrecord.
This should give you a better idea of why cdrecord is failing.  If the
error messages from -vv are not enough, you can also add -VV, although
this affects the timing of the operations, and should be used with
care when recording.

I have had problems like this in the past, when a disk was corrupted,
and cdrecord balked at blanking it.  I used blank=all with either the
-immed flag, or the -force flag, or both, to solve the problems.

If you are using cdrtools, you should probably use the cd(4) driver
together with atapicam(4), rather than the acd(4) driver.  To prevent
possible problems, it is safer to prevent both drivers from attaching
to the same device.  I usually remove:

device atapicd

from my kernel, and just use:

device ata
device atapicam
device scbus
device cd
device pass

I don't know whether it is possible to disable the acd(4) driver using
just loader.conf(5), device.hints(5), or some other means at boot- or
run-time, but you could look into that if you don't want to go to the
trouble of removing it from your kernel.

b.



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?d873d5be0908151102n5bafe979sa1ccf42654600909>