Date: Thu, 07 Apr 2005 09:23:21 -0400 From: Eric McCoy <emccoy@haystacks.org> To: Bill <beau@billbeau.net> Cc: freebsd-questions@freebsd.org Subject: Re: multiprocessors Message-ID: <42553449.3000306@haystacks.org> In-Reply-To: <1112852084.22155.27.camel@ws2.billbeau.net> References: <1112849066.22153.19.camel@ws2.billbeau.net> <4254B432.7070401@gmx.net> <1112852084.22155.27.camel@ws2.billbeau.net>
next in thread | previous in thread | raw e-mail | index | archive | help
Bill wrote: > On Wed, 2005-04-06 at 21:16, FreeBSD Deamon wrote: >>Bill wrote: >>>Is there a comand to use so as to see if freebsd is using both >>>processors? sysctl hw.ncpu, I think. You can also look at /var/run/dmesg.boot and look for: FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs cpu0 (BSP): APIC ID: 1 cpu1 (AP): APIC ID: 0 BSP stands for bootstrap processor and AP for application processor. The BSP is the one used to load the system until this message comes up: SMP: AP CPU #1 Launched! which will happen right before the kernel launches init. >>try top(1) >> >>the output of top should contain a "C" column. if this column contains >>"0"s and "1"s both your CPUs are used > There is a line for cpu put it only shows one. Im used to linux and when > I do a top in Linux I see two lines for my cpus. You are looking in the wrong place. A C *column*, not a CPU *row*. FreeBSD will only ever show the total CPU time on the CPU row. This is something like what you will see on an SMP system: PID USERNAME PRI NICE SIZE RES STATE C TIME WCPU CPU COMMAND 89704 emccoy 96 0 2484K 1660K CPU1 0 0:00 0.51% 0.05% top 97005 root 96 0 3092K 1248K select 1 29:28 0.00% 0.00% ntpd First, note the state for top: it's CPU1. Second, the "C" column is 0 for top, 1 for ntpd. The "C" column is the last CPU the process ran on. The WCPU and CPU columns, by the way, are both *per-CPU*, as you can see here: CPU states: 2.7% user, 0.0% nice, 47.5% system, 0.8% interrupt, 49.0% idle 89739 emccoy 110 0 1324K 684K CPU0 0 0:43 99.00% 87.50% cat So another way to tell if SMP is working is if the summary row says 50% idle but you've got a process which shows 100% active. > Is the stock kernel that gets installed when doing a new install smp > enabled? No. > Do i need to rebuild my kernel for smp? Yes. The good news is that it's very easy. The Handbook has information on how to do it. Basically all you need to do is add "options SMP" and make sure "device apic" is enabled (it is by default I believe, even for the GENERIC kernel).
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?42553449.3000306>