Date: Thu, 14 Jun 2001 17:08:42 +1000 From: Paul Thornton <prt@prt.org> To: mobile@freebsd.org Subject: Re: Vaio PCG-XG9 Problem (info included this time) Message-ID: <5.0.2.1.0.20010614170428.05223b50@juno.prt.org> In-Reply-To: <5.0.2.1.0.20010614162652.0534b500@juno.prt.org> References: <20010613145754.C47601@stevenwills.com>
next in thread | previous in thread | raw e-mail | index | archive | help
At 16:34 14/06/01 +1000, I wrote:
>Steve,
>
>As an aside from your sound woes, have you managed to make the PCMCIA slot
>on the docking station work properly? It appears happily in the dmesg but
>then is pretty much non-funtional after that.
Of course, I might get further in general if I remembered to stick in some
useful information... In case it wasn't obvious, this is also an XG9;
running 4.2-REL - dmesg follows:
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.2-RELEASE #5: Tue Dec 5 00:35:04 GMT 2000
root@emma.prt.org:/usr/src/sys/compile/EMMA-2
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (496.31-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x681 Stepping = 1
Features=0x387f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,PN,MMX,FXSR,SSE>
real memory = 134152192 (131008K bytes)
avail memory = 126857216 (123884K bytes)
Preloaded elf kernel "kernel" at 0xc03ab000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc03ab09c.
Pentium Pro MTRR support enabled
md0: Malloc disk
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <NeoMagic MagicMedia 256AV SVGA controller> at 0.0 irq 9
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfc90-0xfc9f at device 7.1 on
pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xfca0-0xfcbf irq 9
at device 7.2 on pci0
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
ums0: Microsoft Microsoft IntelliMouse \M-. with IntelliEye, rev 1.10/1.07,
addr 2, iclass 3/1
ums0: 3 buttons and Z dir.
chip1: <Intel 82371AB Power management controller> port 0x1040-0x104f at
device 7.3 on pci0
pci0: <unknown card> (vendor=0x104d, dev=0x8039) at 8.0 irq 9
pcm0: <Yamaha DS-1E (YMF744)> port 0xfc8c-0xfc8f,0xfcc0-0xfcff mem
0xfedf8000-0xfedfffff irq 9 at device 9.0 on pci0
pcic-pci0: <Ricoh RL5C478 PCI-CardBus Bridge> at device 12.0 on pci0
pcic-pci1: <Ricoh RL5C478 PCI-CardBus Bridge> at device 12.1 on pci0
pcic-pci2: <Ricoh RL5C475 PCI-CardBus Bridge> at device 16.0 on pci0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <32 virtual consoles, flags=0x300>
sbc0: <Soundblaster Pro> at port 0x220-0x22f irq 5 drq 1 flags 0x15 on isa0
pcm1: <SB DSP 3.01> on sbc0
pcic0: <Intel i82365> at port 0x3e0 iomem 0xd0000 irq 11 drq 0 on isa0
pcic0: management irq 11
pcic0: Polling mode (forced to poll mode mod in pcic.c prt 4/12/2000)
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
plip0: <PLIP network interface> on ppbus0
pccard: card inserted, slot 1
ata1-slave: ata_command: timeout waiting for intr
ata1-slave: identify failed
ata1-master: ata_command: timeout waiting for intr
ata1-master: identify failed
ad0: 17301MB <IBM-DARA-218000> [35152/16/63] at ata0-master UDMA33
Mounting root from ufs:/dev/ad0s2a
--
Paul Thornton
Cambridge, UK.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?5.0.2.1.0.20010614170428.05223b50>