Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 8 Jan 1997 22:40:38 +0100 (MET)
From:      Josef Belkovics <belkovic@albert.osu.cz>
To:        freebsd-bugs@freebsd.org
Subject:   AIC-7770 (TwinChannel fast SCSI-2 controller (in HP NetServer LC))
Message-ID:  <Pine.BSF.3.91.970108220358.290A-100000@albert.osu.cz>

next in thread | raw e-mail | index | archive | help
In 2.1.0R controller ahc1 was in GENERIC kernel and all was ok. In 2.1.5R or
2.1.6R ahc1 isn't in GENERIC. I installed 2.1.6R from 2.1.0R boot.flp and 
copied kernel 2.1.0R from another PC. The build of 2.1.6R kernel is ok, 
but ahc1 (or ahc0 - I don't know the difference between it) isn't detected.
2 questions:
1) Exists some release higher 2.1.0 with correct "driver" for ahc1?
2) Can you put back ahc? in boot.flp?
OK#############################################################################

machine		"i386"
cpu		"I586_CPU"
ident		"JPB5"
maxusers	10
config		kernel	root on sd0 

#ptions		MATH_EMULATE		#Support for x87 emulation
options		"COMPAT_43"		#Compatible with BSD 4.3
options		FFS			#Berkeley Fast Filesystem
options		PROCFS			#Process filesystem
options		"NSWAPDEV=1"		#Allow this many swap-devices
options		QUOTA			#Enable disk quotas
options		UCONSOLE		#Allow users to grab the console
options		"MAXCONS=4"		#Number of virtual consoles
options		INET			#InterNETworking
#ptions		GATEWAY			#InterNETwork gateway
#ptions		MROUTING		#Multicast routing
options		"AUTO_EOI_1"		#Automatic EOI for the master 8259A
options		"AUTO_EOI_2"		#Automatic EOI for the slave 8259A
options		DUMMY_NOPS		#Disables extra delays for some bus opsoptions		"MAXCONS=5"		#Number of virtual consoles		
options		SYSVSHM			#Enable for share memory
options		SYSVSEM			#Enable for semaphores
options		SYSVMSG			#Enable for messaging

controller	isa0
controller	pci0

device		sc0	at isa? port "IO_KBD"	tty irq  1	 vector scintr
#evice		sio1	at isa? port "IO_COM2"	tty irq  3	 vector siointr
device		sio0	at isa? port "IO_COM1"	tty irq  4	 vector siointr
#evice		mse0	at isa? port 0x23c	tty irq  5	 vector mseintr
controller	fdc0	at isa? port "IO_FD1"	bio irq  6 drq 2 vector fdintr
disk		fd0	at fdc0 drive 0
#evice		lpt0	at isa? port?		tty irq  7	 vector lptintr
device		ep0	at isa? port 0x300	net irq 10	 vector epintr
device		npx0	at isa? port "IO_NPX"	    irq 13	 vector npxintr
#ontroller	wdc0	at isa? port "IO_WD1"	bio irq 14	 vector wdintr
#isk		wd0	at wdc0 drive 0
!!!controller	ahc1	at isa?			bio irq  ?	 vector ahcintr
!!!controller	scbus0
device		sd0
device		sd1
#evice		cd0

pseudo-device	loop
pseudo-device	ether
pseudo-device	log
pseudo-device	sl	1
#seudo-device	ppp	1
#seudo-device	tun	1
pseudo-device	pty	16
pseudo-device	gzip
#seudo-device	vn

FreeBSD 2.1.0-RELEASE #0: Fri Sep  6 02:06:50 MET DST 1996
     root@isac.osu.cz:/usr/src/sys/compile/JPB5
CPU: 67-MHz Pentium 510\60 or 567\66 (Pentium-class CPU)
     Origin = "GenuineIntel"  Id = 0x517  Stepping=7
     Features=0x1bf<FPU,VME,PSE,MCE,CX8,APIC>
real memory  = 50331648 (49152K bytes)
avail memory = 47955968 (46832K bytes)
Probing for devices on the ISA bus:
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: VGA color <4 virtual consoles, flags=0x0>
sio0 at 0x3f8-0x3ff irq 4 on isa
sio0: type 16550A
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: NEC 72065B
fd0: 1.44MB 3.5in
ahc1: Motherboard Twin Channel, A SCSI Id=7, B SCSI Id=7, aic7770 >= Rev E, 4 SCBs
ahc1 at 0xb000-0xb0ff irq 15 on eisa slot 11
(ahc1:0:0): "HP 1.050 GB #A2 0180" type 0 fixed SCSI 2
sd0(ahc1:0:0): Direct-Access 1001MB (2051460 512 byte sectors)
(ahc1:1:0): "SEAGATE ST51080N 0943" type 0 fixed SCSI 2
sd1(ahc1:1:0): Direct-Access 1030MB (2109840 512 byte sectors)
1 3C5x9 board(s) on ISA found at 0x300
ep0 at 0x300-0x30f irq 10 on isa
ep0: aui/bnc/utp[*UTP*] address 00:20:af:b7:53:06 irq 10
npx0 on motherboard
npx0: INT 16 interface
Probing for devices on the PCI bus:
chip0 <Intel 82434LX (Mercury) PCI cache memory controller> rev 3 on pci0:0
chip1 <Intel 82375EB PCI-EISA bridge> rev 4 on pci0:4

BAD###########################################################################

machine		"i386"
cpu		"I586_CPU"
ident		"JPB5"
maxusers	10
config		kernel	root on sd0 

#ptions		MATH_EMULATE		#Support for x87 emulation
options		"COMPAT_43"		#Compatible with BSD 4.3
options		FFS			#Berkeley Fast Filesystem
options		PROCFS			#Process filesystem
options		"NSWAPDEV=1"		#Allow this many swap-devices
options		QUOTA			#Enable disk quotas
options		UCONSOLE		#Allow users to grab the console
options		"MAXCONS=4"		#Number of virtual consoles
options		INET			#InterNETworking
#ptions		GATEWAY			#InterNETwork gateway
#ptions		MROUTING		#Multicast routing
options		"AUTO_EOI_1"		#Automatic EOI for the master 8259A
options		"AUTO_EOI_2"		#Automatic EOI for the slave 8259A
options		DUMMY_NOPS		#Disables extra delays for some bus opsoptions		"MAXCONS=5"		#Number of virtual consoles		
options		SYSVSHM			#Enable for share memory
options		SYSVSEM			#Enable for semaphores
options		SYSVMSG			#Enable for messaging

controller	isa0
!!!controller	eisa0
controller	pci0

device		sc0	at isa? port "IO_KBD"	tty irq  1	 vector scintr
#evice		sio1	at isa? port "IO_COM2"	tty irq  3	 vector siointr
device		sio0	at isa? port "IO_COM1"	tty irq  4	 vector siointr
#evice		mse0	at isa? port 0x23c	tty irq  5	 vector mseintr
controller	fdc0	at isa? port "IO_FD1"	bio irq  6 drq 2 vector fdintr
disk		fd0	at fdc0 drive 0
#evice		lpt0	at isa? port?		tty irq  7	 vector lptintr
device		ep0	at isa? port 0x300	net irq 10	 vector epintr
device		npx0	at isa? port "IO_NPX"	    irq 13	 vector npxintr
#ontroller	wdc0	at isa? port "IO_WD1"	bio irq 14	 vector wdintr
#isk		wd0	at wdc0 drive 0
#ontroller	ahc1	at isa?			bio irq  ?	 vector ahcintr
!!!controller	ahc0
!!!controller	scbus0	at ahc0
device		sd0
device		sd1
#evice		cd0

pseudo-device	loop
pseudo-device	ether
pseudo-device	log
pseudo-device	sl	1
#seudo-device	ppp	1
#seudo-device	tun	1
pseudo-device	pty	16
pseudo-device	gzip
pseudo-device	vn

FreeBSD 2.1.6-RELEASE #0: etc.
     root@isac.osu.cz:/usr/src/sys/compile/JPB5
CPU: 67-MHz Pentium 510\60 or 567\66 (Pentium-class CPU)
     Origin = "GenuineIntel"  Id = 0x517  Stepping=7
     Features=0x1bf<FPU,VME,PSE,MCE,CX8,APIC>
real memory  = 50331648 (49152K bytes)
avail memory = 47955968 (46832K bytes)
eisa0: <HWPc081 (System Board)>
!!!Probing for devices on the EISA bus:
Probing for devices on the PCI bus:
chip0 <Intel 82434LX (Mercury) PCI cache memory controller> rev 3 on pci0:0
chip1 <Intel 82375EB PCI-EISA bridge> rev 4 on pci0:4
Probing for devices on the ISA bus:
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: VGA color <4 virtual consoles, flags=0x0>
sio0 at 0x3f8-0x3ff irq 4 on isa
sio0: type 16550A
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: NEC 72065B
fd0: 1.44MB 3.5in
1 3C5x9 board(s) on ISA found at 0x300
ep0 at 0x300-0x30f irq 10 on isa
ep0: aui/bnc/utp[*UTP*] address 00:20:af:b7:53:06 irq 10
npx0 on motherboard
npx0: INT 16 interface

panic: cannot mount root

###############################################################################



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.3.91.970108220358.290A-100000>