Date: Wed, 18 May 2011 08:31:17 +1200 From: Andrew Turner <andrew@fubar.geek.nz> To: Mark Murray <markm@FreeBSD.org> Cc: freebsd-arm@freebsd.org Subject: Re: OMAP3 patch Message-ID: <20110518083117.761cf4c7@fubar.geek.nz> In-Reply-To: <E1QIfVW-000PYG-F9@groundzero.grondar.org> References: <20110425163549.2bcc8551@fubar.geek.nz> <20110425170105.37c7d853@fubar.geek.nz> <E1QEKCz-0005xT-5R@groundzero.grondar.org> <20110426035423.1b4b592c@fubar.geek.nz> <E1QIfVW-000PYG-F9@groundzero.grondar.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On Sat, 07 May 2011 12:17:10 +0100 Mark Murray <markm@FreeBSD.org> wrote: > Did this. Didn't work: > > [graveyard] /usr/src 12:08 pm # cu -t -s 115200 -l /dev/cuaU0 > Connected > > > Texas Instruments X-Loader 1.4.4ss (Aug 19 2010 - 02:49:27) > Beagle xM Rev A > Reading boot sector > Loading u-boot.bin from mmc It appears you have a Beagleboard-xM. I haven't had a chance to test booting on the xM yet so it may be broken. The xM also needs a driver written to enable the USB host hardware. > U-Boot 2010.03-dirty (Aug 20 2010 - 20:50:46) > > OMAP3630/3730-GP ES2.0, CPU-OPP2, L3-165MHz, > OMAP3 Beagle board + LPDDR/NAND > I2C: ready > DRAM: 512 MB > NAND: 256 MiB > *** Warning - bad CRC or NAND, using default environment > > In: serial > Out: serial > Err: serial > > Probing for expansion boards, if none are connected you'll see a > harmless I2C error. > > No EEPROM on expansion board > Beagle xM Rev A > Die ID #7f4c00011ff00000015739eb0c00b026 > Hit any key to stop autoboot: 0 > mmc1 is available > The user button is currently NOT pressed. > reading boot.scr > > ** Unable to read "boot.scr" from mmc 1:1 ** > reading user.scr > > ** Unable to read "user.scr" from mmc 1:1 ** > reading uImage > > 3994161 bytes read > Booting from mmc ... > ## Booting kernel from Legacy Image at 80200000 ... > Image Name: FreeBSD > Image Type: ARM Linux Kernel Image (uncompressed) > Data Size: 3994097 Bytes = 3.8 MB > Load Address: 80200000 > Entry Point: 802000e0 > Verifying Checksum ... OK > XIP Kernel Image ... OK These addresses are interesting. I don't think XIP will work. You can try to load the image to a different address in U-Boot or build FreeBSD to run at a different address. Andrew
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20110518083117.761cf4c7>