Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 11 Apr 2005 19:53:50 +0200
From:      Danny Pansters <danny@ricin.com>
To:        freebsd-questions@freebsd.org
Subject:   Re: Very slow printing with stock FreeBSD5.3 + CUPS + Gimp-Print + HPDeskJet612C
Message-ID:  <200504111953.50158.danny@ricin.com>
In-Reply-To: <425AAB51.5020808@tvog.net>
References:  <3d4917d89fcf710e1ada055cb7bd4de9@asu.edu> <425A76AE.5010606@makeworld.com> <425AAB51.5020808@tvog.net>

next in thread | previous in thread | raw e-mail | index | archive | help
On Monday 11 April 2005 18:52, Frank Laszlo wrote:
> Chris wrote:
> >Anthony M. Agelastos wrote:
> >>Hello all,
> >>
> >>My HP DeskJet 612C printer is printing unbearably slow (0.033 PPM). I
> >>have a stock installation (GENERIC KERNEL) of FreeBSD 5.3 straight off
> >>of the install CDs, and I have installed very little software thus far.
> >>I have mainly followed the installation instructions from
> >>
> >>http://www.csua.berkeley.edu/~ranga/notes/freebsd_cups.html
> >>
> >>It basically prints one line at a time, then pauses for a while, and
> >>makes some noises, and then repeats. The whole single test page took
> >>over 30 minutes to print. Does anyone have any insight/info that they
> >>can give me to solve this problem or point me in the right direction of
> >>solving it? I have Googled and done some searching and did not come up
> >>with anything. I checked the CUPS documentation and forums and did not
> >>see anything either.

Gimp-print is about the worst one could use. Use hpijs.

> >Anthony,
> >
> >	I too have this issue. I tried with my HP 1100, 1300 and a 4050 on 3
> >differant PC/laptops.  The thing is, one of them, like yours, was a
> >generic install w/gnome and I tried bot apsfilter and CUPS.
> >
> >	Yet, everyone I have spoken with has no idea of the issues I'm dealing
> >with. So for now, and untill I pop on 5.4, I'm gonna leave my printing
> >for Windows.
> >
> >	Yes, I tried the install via the Handbook, read the docs for apfilter,
> >and the closest I get to printing is via CUPS - and with the same issues
> >(and worse then you). Mine happen to be the "GO" light flashes for 20
> >minutes befor anything spits out.  *shrug*

Use hpijs (and hpoj) with cups. Works really well on my photosmart 2610 
all-in-one thing. They're ports from HP's drivers for Linux:

/usr/ports/print/hpijs
/usr/ports/graphics/hpoj

>
> Perhaps the quality setting is locked on high resolution? This would
> probably make the printer print quite slow if its an inkjet.
>
> Regards,
>     Frank Laszlo

HTH,

Dan



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200504111953.50158.danny>