Date: Tue, 23 Aug 2005 13:29:28 +0200 From: =?ISO-8859-1?Q?Jimmy_B=E4ckstr=F6m?= <jimmy.backstrom@crystone.se> To: "freebsd-questions@freebsd.org" <freebsd-questions@freebsd.org> Subject: Re: FAILURE - SETFEATURES SET TRANSFER MODE status=41 Message-ID: <430B0898.6050309@crystone.se>
next in thread | raw e-mail | index | archive | help
Alex Zbyslaw wrote: > Jimmy Bäckström wrote: > >> Hi list! >> I've googled and searched the mailing list archives for this but >> couldn't find anything useful. >> I just installed freebsd 5.4 on a dell PE 2850 with RAID5 (PERC). The >> installation goes fine and as far as I can tell it runs ok, haven't >> really done anything with yet though so I can be wrong, but when >> booting I get two messages that concerns me: >> >> ata2-master: FAILURE - SETFEATURES SET TRANSFER MODE >> status=41<READY,ERROR> error=4<ABORTED> >> ata2-slave: FAILURE - SETFEATURES SET TRANSFER MODE >> status=41<READY,ERROR> error=4<ABORTED> >> >> and >> >> Interrupt storm detected on "irq18: uhci2"; throttling interrupt source >> >> When it comes to the ata2-master/slave errors I understand that they >> happen for quite a few people running later versions of freebsd? I >> haven't found anything on the net that points directly at my hardware >> specifics, it seems to happen to a lot of different drives. I'm using >> 4 seagate harddrives by the way. >> >> If this problem has been adressed on the list before, I apologise, I >> couldn't find anything about it. I appreciate any pointers and if >> someone wants me to post dmesg just ask. >> > Set up two of these servers recently. > > We totally ignored the interrupt storm. We couldn't make it go away > but it seemed to do no harm. > > The ata errors are froeither related to the DRAC virtual devices, or > the real CD, if you have one. They seem to confuse atapicam. If you > take atapicam out of the kernel the messages will go away. Your hard > drives are SCSI and have nothing to do with ata. > > --Alex > > > _______________________________________________ > freebsd-questions@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to > "freebsd-questions-unsubscribe@freebsd.org" > Doh! Didn't even think about the drives being SCSI. My bad. :) About atapicam, I can't find it in the kernel config, what line should I be looking for?Re: -- Vänligen/regards Jimmy Bäckström Support Crystone AB www.crystone.se
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?430B0898.6050309>