Date: Tue, 12 Sep 2000 22:18:41 +0200 From: jr@paranoia.demon.nl To: Steve Van Den Akker <vandena@ispchannel.com> Cc: "JP (J. Patrick Russell)" <jr@paranoia.demon.nl>, freebsd-questions@FreeBSD.ORG Subject: Re: Dual homed host routing problem Message-ID: <200009122018.WAA00658@pig.bigmama.xx> In-Reply-To: Message from Steve Van Den Akker <vandena@ispchannel.com> of "Tue, 12 Sep 2000 05:35:56 CDT." <Pine.BSF.4.21.0009120533230.3825-100000@FreeBSD.ispchannel.com>
next in thread | previous in thread | raw e-mail | index | archive | help
No I hadn't done that, but have now. Same problem. I ended up following his instructions up until the part that reads: "At this point, you should have a working gateway machine. Test to make sure machines on the local network can access the Internet." Thanks anyway (plus I can use the site later perhaps). Patrick > Have you checked out the "cheat sheet" found at > www.mostgraveconcern.com/freebsd? I got mine to work the first > time. > > Did you configure the cards themselves properly (IRQ's, etc.)? > > On Mon, 11 Sep 2000, JP (J. Patrick Russell) wrote: > > > HELP! I'm trying to setup a dual homed host with two ethernet devices. Only > > one device seems to be forwarding. ed1 never seems to fully forward, I have > > switched the card out with another type (rl0), but the behavior was identical > > -- only interface ed0 worked. ed1 is recognized and the cards do not seem to > > conflict: > > > > dmesg relevant output: > > > > ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0x6000-0x601f irq 11 at device > > 12.0 on pci0 > > ed0: address 52:54:00:da:22:0c, type NE2000 (16 bit) > > ed1: <NE2000 PCI Ethernet (RealTek 8029)> port 0x6100-0x611f irq 10 at device > > 14.0 on pci0 > > ed1: address 52:54:00:da:21:6d, type NE2000 (16 bit) > > > > and ed1 is automatically added to the routing table: > > > > Internet: > > Destination Gateway Flags Netif Expire > > default 172.16.1.2 UGSc ed1 > > 127.0.0.1 127.0.0.1 UH lo0 > > 172.16.1/24 link#2 UC ed1 => > > 172.16.1.2 link#2 UHLW ed1 => > > 172.16.1.3 52:54:0:da:21:6d UHLW lo0 > > 192.168.118 link#1 UC ed0 => > > 192.168.118.1 52:54:0:da:22:c UHLW lo0 > > 192.168.118.2 0:e0:4c:66:77:3d UHLW ed0 750 > > > > getting to the ed1 interface from the ed0 subnet works, but nothing gets > > forwarded beyond the nic. > > gateway_enable="YES" is set in rc.conf, and sysctl is set so > > net.inet.ip.forwarding=1 > > > > Help? > > > > Thanks > > > > Patrick Russell To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200009122018.WAA00658>