Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 18 Jun 2002 07:13:24 +0200
From:      "[brano]" <brano@zahrobie.sk>
To:        "Helpdesk, Melbourne Data Centre" <HelpdeskMelbourne@eaton.com>
Cc:        "FreeBSD-Questions" <freebsd-questions@FreeBSD.ORG>
Subject:   Re: SiS 900 problem - FreeBSD 4.5 RELEASE 
Message-ID:  <0de501c21686$e11873a0$c28c630a@brano>
References:  <510060498799D411910600508BF3B20E0172A627@melausmb01.mel.au.etn.com>

next in thread | previous in thread | raw e-mail | index | archive | help
Hi,
I have Sis 900x to and it works fine with FreeBSD 4.5 Release with GENERIC
kernel. If you compile own kernel maybe you don't include device  miibus in
kernel file.
Brano from Slovakia

----- Original Message -----
From: "Helpdesk, Melbourne Data Centre" <HelpdeskMelbourne@eaton.com>
To: <freebsd-questions@FreeBSD.ORG>
Sent: Tuesday, June 18, 2002 4:47 AM
Subject: SiS 900 problem - FreeBSD 4.5 RELEASE


> I recently bought a new motherboard (Asus P4S333-VM) with an on-board
SiS900
> ethernet controller integrated into the SIS650 chipset with an ICS
1893Y-01
> LAN PHY chip.
>
> When trying to install FreeBSD the following message appears:-
>
> From my dmesg:
>   > sis0: <SiS 900 10/100BaseTX> port 0xa000-0xa0ff mem
> 0xe6000000-0xe6000fff irq 5 at device 3.0 on pic 0
>   > sis0: Ethernet address: 00:e0:18:72:10:40
>   > sis0: MII without any PHY!
>   > device_probe_and_attach: sis0 attach returned 6
>
> Then the device disappears and is not accessible.
>
> Any tips? Patches? Information?
>
> This problem is especially tiresome as this motherboard is fitted in a
> low-profile case which does not allow for full size PCI cards, so I can't
> even fit a normal network card to get around the issue.
>
> Thank you for your time and assistance with this matter.
>
> best Regards,
>
> Andrew Starkey.
>
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-questions" in the body of the message
>


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?0de501c21686$e11873a0$c28c630a>