Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 19 May 2000 13:34:22 -0400 (EDT)
From:      Ted Buswell <tbuswell@acadia.net>
To:        wietse@porcupine.org (Wietse Venema)
Cc:        freebsd-mobile@FreeBSD.ORG, freebsd-scsi@FreeBSD.ORG
Subject:   Re: Need FreeBSD 4.0 removable SCSI support
Message-ID:  <14629.31234.408264.179584@smpbox>
In-Reply-To: <20000519165619.3AC404563D@spike.porcupine.org>
References:  <14629.21138.578322.41745@smpbox> <20000519165619.3AC404563D@spike.porcupine.org>

next in thread | previous in thread | raw e-mail | index | archive | help

Wietse Venema writes:
 > Ted Buswell:
 > > I'm not sure about yours, but my 1460B does not list irq 3 as one of
 > > the valid IRQ's that it can generate.  Check "pccardc dumpcis" and
 > > search for IRQ.  While "timed out" messages could also be cable/device
 > > related, on my setup they indicated an IRQ conflict.
 > 
 > Here's one data point with FreeBSD 3.4+PAO, same machine:
 > 
 >     card0: assign aic0 iobase 0x340 irq 3
 >     aic0: aic6360, dma, disconnection, parity check
 >     (da0:aic0:0:0:0): ccb 0xc07c3800 - timed out, phase 0x0, state 0
 >     da0 at aic0 bus 0 target 0 lun 0
 >     da0: <iomega jaz 2GB E.15> Removable Direct Access SCSI-2 device 
 >     da0: 5.000MB/s transfers (5.000MHz, offset 8)
 >     da0: 1911MB (3915600 512 byte sectors: 64H 32S/T 1911C)
 > 
 > So the driver does gripe, but it survives, and that's what I need.
 > 
 > 	Wietse


Are you getting any errors other than during the rescan (i.e. while
actually using the disk) ?

-Ted


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-scsi" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?14629.31234.408264.179584>