Date: Sun, 28 Oct 2012 22:42:49 +0200 From: Alexander Motin <mav@FreeBSD.org> To: Big Yuuta <init.py@gmail.com> Cc: freebsd-questions@freebsd.org Subject: Re: No sound from speaker, using Realtek ALC269 and snd_hda Message-ID: <508D98C9.30603@FreeBSD.org> In-Reply-To: <CAN5iB8T9RySw4h5HaM=pCA_G8n4yVa%2BAwdz4_YO8yr-FFk3iZg@mail.gmail.com> References: <CAN5iB8RJe=JY2zsDG40gtCwcf4uJBt0%2BtxiSSuHqnZ1Ob6=HZg@mail.gmail.com> <508D8755.1080501@FreeBSD.org> <CAN5iB8T9RySw4h5HaM=pCA_G8n4yVa%2BAwdz4_YO8yr-FFk3iZg@mail.gmail.com>
next in thread | previous in thread | raw e-mail | index | archive | help
On 28.10.2012 22:09, Big Yuuta wrote:
>> CODEC configuration looks good and I see no problems in driver output. I
>> think most likely problem is in CODEC wiring and power amplifier. Your CODEC
>> has two GPIO lines and EAPD line. That gives 8 possible combinations. I
>> would recommend you to try them all. GPIOs, as you tried could be set with
>> hint.hdaa.0.gpio_config tunable. EAPD line can be controlled (0 or 100) by
>> the ogain mixer control.
>
> You mean combinations like:
>
> hint.hdaa.0.gpio_config="0=set 1=set 2=set"
As I've told, there are only two GPIO pins, so only "0=X 1=Y", plus
ogain mixer control.
> Where the values could be "set" or "keep"? But then again, the man
> also cites "clear", "disable", "input". So that'd make more than 8 possible
> permutations? Or is it something else? Can you please give me an example?
GPIO pins are bidirectional, but I have doubt that input or high
impedance ("disable") state could be used to control something. "keep"
is also useless, as by default these pins are disabled. So you have only
"set" and "clear".
> Also, can I, after booting, just try with:
>
> kenv hint.hdaa.0.gpio_config="0=set 1=set 2=set"
> kdunload snd_hda.ko
> kdload snd_hda.ko
Yes, that should work.
> or should I reboot each time?
I don't think it is required.
--
Alexander Motin
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?508D98C9.30603>