Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 15 Feb 2013 21:02:14 +0100
From:      Kamil Szczesny <k.s.mail@gmx.net>
To:        Adrian Chadd <adrian@freebsd.org>
Cc:        freebsd-wireless@freebsd.org
Subject:   Re: ath0: device timeout on 9.1-RELEASE
Message-ID:  <511E9446.4070708@gmx.net>
In-Reply-To: <CAJ-Vmon9FskQtUdZ_nnTer6n7cGznqWQ6c4MZTm4DqT9cNTTng@mail.gmail.com>
References:  <51175C69.6050003@gmx.net> <CAJ-Vmo=5ReDqivQakH9Yuv20_wvqCqHtsxoqpYKhh=-RvpUt%2Bg@mail.gmail.com> <51189E1E.70206@gmx.net> <CAJ-Vmo=HLRkXb6NyU=tR_GbPPdu7DFQMsFrXD2qXBzdC%2BMb%2BxQ@mail.gmail.com> <51194795.5070500@gmx.net> <CAJ-VmomB7t-tEb=LCUZkGqsv0YQqqQEFT-Zq8sndqAbJsNZJsA@mail.gmail.com> <511E910D.1080901@gmx.net> <CAJ-Vmon9FskQtUdZ_nnTer6n7cGznqWQ6c4MZTm4DqT9cNTTng@mail.gmail.com>

next in thread | previous in thread | raw e-mail | index | archive | help
Am 15.02.2013 20:55, schrieb Adrian Chadd:
> Sure, that shows that your environment is quite noisy. :-)
>
> But is transmission just plain not happening? Is it just never
> associating? Or is it sometimes associating and sometimes not?
>


It's a bit crowded here ; )

Well as far as I have observed, it never associated.

regards,
Kamil

>
>
> Adrian
>
>
> On 15 February 2013 11:48, Kamil Szczesny <k.s.mail@gmx.net> wrote:
>> Adrian,
>>
>> Finally, I managed to get again a 9.1-RELEASE running with a recompiled
>> kernel.
>>
>> gomorrha% uname -v
>> FreeBSD 9.1-RELEASE #0 r246834: Fri Feb 15 18:57:51 CET 2013
>> root@gomorrha.local:/usr/obj/usr/src/sys/WIFIDEBUG
>>
>> This is the result of athstats:
>>
>> gomorrha% /usr/local/bin/athstats -i ath0
>> 32484    data frames received
>> 5130     data frames transmit
>> 3273     mib overflow interrupts
>> 1M       current transmit rate
>> 190      watchdog timeouts
>> 2040     rx failed 'cuz of bad CRC
>> 7        rx failed 'cuz of PHY err
>>      7        CCK restart
>> -0/+0    TDMA slot adjust (usecs, smoothed)
>> 86       avg recv rssi
>> -96      rx noise floor
>> 5130     tx frames through raw api
>> 1        first step level
>> 1        OFDM weak signal detect
>> 12       ANI increased spur immunity
>> 10       ANI decrease spur immunity
>> 990      ANI enabled OFDM weak signal detect
>> 2061     ANI disabled OFDM weak signal detect
>> 3041     ANI disabled CCK weak signal threshold
>> 4        ANI increased first step level
>> 2940667  cumulative OFDM phy error count
>> 5258173  cumulative CCK phy error count
>> 74       bad FCS
>> 105      average rssi (beacons only)
>> 84       average rssi (all rx'd frames)
>> Antenna profile:
>> [1] tx        0 rx    32484
>>
>> Is it somewhat helpful?
>>
>> regards,
>> Kamil
>>
>> Am 11.02.2013 20:43, schrieb Adrian Chadd:
>>
>>> Ok..
>>>
>>> On 11 February 2013 11:33, Kamil Szczesny <k.s.mail@gmx.net> wrote:
>>>>
>>>> Still with 9.0-RELEASE:
>>>>
>>>> gomorrha% vmstat -i
>>>> interrupt                          total       rate
>>>> irq1: atkbd0                           6          0
>>>> irq16: ath0 ehci0                   1367         13
>>>
>>>
>>> .. I can't tell here whether there's any interrupts making it to the
>>> ath0 device or not.
>>>
>>> The driver in -HEAD logs the TX and RX interrupt counts in a ath
>>> sysctl which I can track.
>>>
>>> Can you please compile up athstats and recompile your kernel with:
>>>
>>> ATH_DEBUG
>>> AH_DEBUG
>>> ATH_DIAGAPI
>>>
>>> .. as we will need to establish whether you're actually queuing frames
>>> to the hardware, whether they're going out, whether the hardware is
>>> actually completing them, and whether the interrupt is being
>>> generated.
>>>
>>> Thanks,
>>>
>>>
>>>
>>> Adrian
>>>
>>>> irq23: ehci1                         250          2
>>>> cpu0:timer                          8014         77
>>>> irq256: em0                          523          5
>>>> irq258: ahci0                      15444        149
>>>> cpu1:timer                          2797         27
>>>> cpu2:timer                          3743         36
>>>> cpu3:timer                          3053         29
>>>> Total                              35197        341
>>>>
>>>>
>>>>
>>>> Am 11.02.13 19:59, schrieb Adrian Chadd:
>>>>
>>>>> Hi,
>>>>>
>>>>> Would you please look at the output of vmstat -i, see if the ath0
>>>>> device is receiving interrupts?
>>>>>
>>>>> Thanks,
>>>>>
>>>>>
>>>>>
>>>>> Adrian
>>>>>
>>>>>
>>>>> On 10 February 2013 23:30, Kamil Szczesny <k.s.mail@gmx.net> wrote:
>>>>>>
>>>>>>
>>>>>> Hi,
>>>>>>
>>>>>> after a downgrade to 9.0-RELEASE the issue remains the same.
>>>>>> /var/log/messages is spamed by equal authentication timeout entries.
>>>>>>
>>>>>> regards,
>>>>>> Kamil
>>>>>>
>>>>>> Am 10.02.13 20:10, schrieb Adrian Chadd:
>>>>>>
>>>>>>> Hi,
>>>>>>>
>>>>>>> Would you please try 9.0-RELEASE too?
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>> Adrian
>>>>>>>
>>>>>>>
>>>>>>> On 10 February 2013 00:38, Kamil Szczesny <k.s.mail@gmx.net> wrote:
>>>>>>>>
>>>>>>>>
>>>>>>>> Hello,
>>>>>>>>
>>>>>>>> I'm facing a problem with ath0 on FreeBSD 9.1-RELEASE, that was not
>>>>>>>> existent
>>>>>>>> on 8.x-RELEASE.
>>>>>>>>
>>>>>>>> The issue seems to be the similar to this one:
>>>>>>>>
>>>>>>>>
>>>>>>>>
>>>>>>>> http://lists.freebsd.org/pipermail/freebsd-stable/2012-January/065667.html
>>>>>>>>
>>>>>>>> I do have the same NIC. pciconf -lv output is equal:
>>>>>>>>
>>>>>>>> ath0@pci0:2:0:0:    class=0x028000 card=0x3a701186 chip=0x0024168c
>>>>>>>> rev=0x01
>>>>>>>> hdr=0x00
>>>>>>>>         vendor     = 'Atheros Communications Inc.'
>>>>>>>>         device     = 'AR5008 Wireless Network Adapter'
>>>>>>>>         class      = network
>>>>>>>>
>>>>>>>> /etc/rc.conf:
>>>>>>>> wlans_ath0="wlan0"
>>>>>>>> ifconfig_wlan0="WPA DHCP"
>>>>>>>>
>>>>>>>> /etc/wpa_supplicant.conf:
>>>>>>>> network={
>>>>>>>> ssid="home"
>>>>>>>> psk="123"
>>>>>>>> }
>>>>>>>>
>>>>>>>> However, it is not starting to work.
>>>>>>>>
>>>>>>>> I do not have /usr/src/tools/ath so that I can not provide the
>>>>>>>> output.
>>>>>>>>
>>>>>>>> /var/log/messages is spammed with:
>>>>>>>>
>>>>>>>> Feb 10 09:08:26 gomorrha wpa_supplicant[1500]: Trying to associate
>>>>>>>> with
>>>>>>>> xx:xx:xx:xx:xx:xx (SSID='home' freq=2422 MHz)
>>>>>>>> Feb 10 09:08:30 gomorrha kernel: ath0: device timeout
>>>>>>>> Feb 10 09:08:36 gomorrha wpa_supplicant[1500]: Authentication with
>>>>>>>> xx:xx:xx:xx:xx:xx timed out.
>>>>>>>>
>>>>>>>> Any idea what might be wrong or how I could fix this?
>>>>>>>>
>>>>>>>> regards,
>>>>>>>> Kamil
>>>>>>>> _______________________________________________
>>>>>>>> freebsd-wireless@freebsd.org mailing list
>>>>>>>> http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
>>>>>>>> To unsubscribe, send any mail to
>>>>>>>> "freebsd-wireless-unsubscribe@freebsd.org"
>>>>>>
>>>>>>
>>>>>>
>>>>
>>>
>>
>



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?511E9446.4070708>