Date: Thu, 20 Feb 2003 11:32:04 -0500 (EST) From: "Andrew R. Reiter" <arr@watson.org> To: Kevin Oberman <oberman@es.net> Cc: current@FreeBSD.ORG Subject: Re: Ethernet (xl) will not transmit or receive Message-ID: <Pine.NEB.3.96L.1030220113026.8683A-100000@fledge.watson.org> In-Reply-To: <20030220161905.BBA6D5D04@ptavv.es.net>
next in thread | previous in thread | raw e-mail | index | archive | help
Kevin, I experienced similar issues yesterday when just installing release 5 from ftp (floppy boot). I essentially had to ifconfig the device down and then back up and it then seemed to continue ok... but I think there most likely something odd going on :/ Cheers, Andrew On Thu, 20 Feb 2003, Kevin Oberman wrote: :I updated my 5.0 system built in late January to RELENG_5_0 on Sunday :and the Ethernet was not working. I tried again last night with no :change in behavior. : :The system is an AMD K6-2 on an ASUS P5A mobo. I have a 3Com 3c905B :Ethernet which had been working fine on a kernel built in late :January. : :The dmesg is not too meaningful, but the system shows no errors. It :simply never receives a packet. ARPs are all incomplete and no packets :are transmitted although netstat -in indicates that they are. The :packets never actually reach the wire, though. : :I can't believe that no one else has this card, but I didn't find :anything in the archives on it. : :Any idea what needs to be rolled back and how far? I'm suspicious that :it might be an mii problem. Maybe even an interrupt issue. I an :suspicious of the second, empty xlphy0: line in the dmesg, but the :reported MAC is right and my old kernel that works seems to generate a :similar empty line. : :Any clues or suggestions appreciated. : :Thanks, : :R. Kevin Oberman, Network Engineer :Energy Sciences Network (ESnet) :Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab) :E-mail: oberman@es.net Phone: +1 510 486-8634 :--[[application/octet-stream :Content-Disposition: attachment; filename="dmesg.boot"][7bit]] :Copyright (c) 1992-2003 The FreeBSD Project. :Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 : The Regents of the University of California. All rights reserved. :FreeBSD 5.0-RELEASE-p1 #2: Wed Feb 19 22:47:50 PST 2003 : root@kzin.es.net:/usr/obj/usr/src/sys/KZIN :Preloaded elf kernel "/boot/kernel/kernel" at 0xc04a0000. :Preloaded userconfig_script "/boot/kernel.conf" at 0xc04a00a8. :Preloaded elf module "/boot/kernel/acpi.ko" at 0xc04a00f8. :Timecounter "i8254" frequency 1193182 Hz :Timecounter "TSC" frequency 451024032 Hz :CPU: AMD-K6(tm) 3D+ Processor (451.02-MHz 586-class CPU) : Origin = "AuthenticAMD" Id = 0x591 Stepping = 1 : Features=0x8021bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX> : AMD Features=0xffffffff80000800<SYSCALL,3DNow!> :real memory = 100646912 (95 MB) :avail memory = 92729344 (88 MB) :Initializing GEOMetry subsystem :K6-family MTRR support enabled (2 registers) :VESA: v2.0, 16384k memory, flags:0x1, mode table:0xc00c6974 (c0006974) :VESA: Matrox Graphics Inc. :npx0: <math processor> on motherboard :npx0: INT 16 interface :acpi0: <ASUS P5A > on motherboard : ACPI-0625: *** Info: GPE Block0 defined as GPE0 to GPE15 : ACPI-0625: *** Info: GPE Block1 defined as GPE16 to GPE31 :Using $PIR table, 8 entries at 0xc00f0ca0 :acpi0: power button is handled as a fixed feature programming model. :Timecounter "ACPI-safe" frequency 3579545 Hz :acpi_timer0: <24-bit timer at 3.579545MHz> port 0xec08-0xec0b on acpi0 :acpi_cpu0: <CPU> on acpi0 :pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0 :pci0: <ACPI PCI bus> on pcib0 :pcib1: <PCI-PCI bridge> at device 1.0 on pci0 :pci1: <PCI bus> on pcib1 :pci1: <display, VGA> at device 0.0 (no driver attached) :pci0: <bridge, PCI-unknown> at device 3.0 (no driver attached) :isab0: <PCI-ISA bridge> at device 7.0 on pci0 :isa0: <ISA bus> on isab0 :pcm0: <AudioPCI ES1373-8> port 0xd800-0xd83f irq 9 at device 9.0 on pci0 :xl0: <3Com 3c905B-TX Fast Etherlink XL> port 0xd400-0xd47f mem 0xde000000-0xde00007f irq 10 at device 11.0 on pci0 :xl0: Ethernet address: 00:50:da:80:4b:43 :miibus0: <MII bus> on xl0 :xlphy0: <3Com internal media interface> on miibus0 :xlphy0: :atapci0: <AcerLabs Aladdin ATA33 controller> port 0xd000-0xd00f at device 15.0 on pci0 :ata0: at 0x1f0 irq 14 on atapci0 :ata1: at 0x170 irq 15 on atapci0 :fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> port 0x3f7,0x3f2-0x3f5 irq 6 drq 2 on acpi0 :fdc0: FIFO enabled, 8 bytes threshold :fd0: <1440-KB 3.5" drive> on fdc0 drive 0 :ppc0 port 0x778-0x77b,0x378-0x37f irq 7 drq 3 on acpi0 :ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode :ppc0: FIFO with 16/16/7 bytes threshold :lpt0: <Printer> on ppbus0 :lpt0: Interrupt-driven port :ppi0: <Parallel I/O> on ppbus0 :sio0 port 0x3f8-0x3ff irq 4 on acpi0 :sio0: type 16550A :sio1 port 0x2f8-0x2ff irq 3 on acpi0 :sio1: type 16550A :atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0 :atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 :kbd0 at atkbd0 :psm0: <PS/2 Mouse> irq 12 on atkbdc0 :psm0: model Generic PS/2 mouse, device ID 0 :orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0 :pmtimer0 on isa0 :sc0: <System console> at flags 0x100 on isa0 :sc0: VGA <16 virtual consoles, flags=0x300> :vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 :Timecounters tick every 10.000 msec :ad0: DMA limited to UDMA33, non-ATA66 cable or device :ad0: 13031MB <FUJITSU MPE3136AT> [26476/16/63] at ata0-master UDMA33 :ad2: 13029MB <Maxtor 91366U4> [26473/16/63] at ata1-master UDMA33 :acd0: CDROM <SONY CD-ROM CDU4821> at ata1-slave UDMA33 :Mounting root from ufs:/dev/ad0s1a :cd0 at ata1 bus 0 target 1 lun 0 :cd0: <SONY CD-ROM CDU4821 S0.M> Removable CD-ROM SCSI-0 device :cd0: 33.000MB/s transfers :cd0: Attempt to query device size failed: NOT READY, Medium not present : :To Unsubscribe: send mail to majordomo@FreeBSD.org :with "unsubscribe freebsd-current" in the body of the message : -- Andrew R. Reiter arr@watson.org arr@FreeBSD.org To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.NEB.3.96L.1030220113026.8683A-100000>