Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 13 Jan 2007 07:16:06 +0100
From:      Milan Obuch <freebsd-hardware@dino.sk>
To:        freebsd-hardware@freebsd.org
Subject:   Re: DWL-G520 low signal, low speed
Message-ID:  <200701130716.08587.freebsd-hardware@dino.sk>
In-Reply-To: <45A85CAF.8060309@errno.com>
References:  <20070110110833.23305.qmail@web52715.mail.yahoo.com> <45A85CAF.8060309@errno.com>

next in thread | previous in thread | raw e-mail | index | archive | help
On Saturday 13 January 2007 05:14, Sam Leffler wrote:
> Trigve Siver wrote:
> > Hi,
> > I have a problem with my wifi DWL G520 atheros chip based card... I have
> > low signal only 20-30% and also a low speed 5-11 Mbit/s..router is only
> > 1-2 m away from me and with gentoo I have 90% signal strength..I'm using
> > FreeBSD 6.2 PRERELEASE
> >
> > $ dmesg -a |grep ath
> > ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,
> > RF5413) ath0: <Atheros 5212> mem 0xe7000000-0xe700ffff irq 19 at device
> > 2.0 on pci2 ath0: Ethernet address: 00:17:9a:af:62:da
> > ath0: mac 7.9 phy 4.5 radio 5.6
> > ath0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 150
> >
> > rc.conf:
> > ifconfig_ath0="WPA inet 192.168.1.15  netmask 255.255.255.0 mode 11g"
> >
> > $ ifconfig ath0
> > ath0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> >         inet 192.168.1.15 netmask 0xffffff00 broadcast 192.168.1.255
> >         ether 00:17:9a:af:62:da
> >         media: IEEE 802.11 Wireless Ethernet autoselect mode 11g
> > (DS/11Mbps) status: associated
> >         ssid 3Com channel 1 bssid 00:12:a9:c4:41:22
> >         authmode WPA privacy ON deftxkey UNDEF TKIP 3:128-bit txpowmax 36
> >         bmiss 7 protmode CTS burst roaming MANUAL bintval 100
> >
> > Anyone could help?
>
> I see no indication of rssi on freebsd or any statistics to show issues
> with lost packets.  gentoo likely uses madwifi which uses the same hal
> (or older) than what is in freebsd.  As such I'd expect no difference in
> operation wrt signal or link level behaviour.
>

Unfortunately, this is the case here too. On one link, approx. 3 km distance, 
I got no link with both sides FreeBSD, athstats reported rssi 6 when one side 
was changed to Linux with madwifi, and rssi 23 when both sides were Linux. I 
was forced to use Linux on all radio links due this. I would like to repeat 
this test indoor, but did not have time yet. This drives me crazy because I 
am forced to use system I don't like :(
Milan

-- 
No need to mail me directly. Just reply to mailing list, please.



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200701130716.08587.freebsd-hardware>