Date: Thu, 07 Dec 2006 11:24:30 +0000 From: Vince <jhary@unsane.co.uk> To: freebsd-questions@freebsd.org Subject: Re: How to use ulpt driver? Message-ID: <4577F9EE.5020203@unsane.co.uk> In-Reply-To: <20061207105323.GA566@host.my.domain> References: <20061207063252.GA769@host.my.domain> <4577E484.7000307@unsane.co.uk> <20061207105323.GA566@host.my.domain>
next in thread | previous in thread | raw e-mail | index | archive | help
a@zeos.net wrote: > On Thu, Dec 07, 2006 at 09:53:08AM +0000, Vince wrote: >> a@zeos.net wrote: >>> I get USB printer Canon PIXMA iP 2000 and attached it to my computer. >>> >>> The kernel was compiled with: >>> >>> # USB support >>> device uhci # UHCI PCI->USB interface >>> device usb # USB Bus (required) >>> device ugen # Generic >>> device uhid # "Human Interface Devices" >>> device umass # Disks/Mass storage - Requires scbus and da >>> >>> and sees the printer: >>> <snip> >>> What is wrong and how will I print? >>> >> when you plug in/turn on the printer with the system booted, what >> appears in your dmesg/messages log? >> >> I see there are some ugen entries in /dev so it might not be recognised >> by the driver correctly. >> >> Vince >> >>> Elisej Babenko > > It is something misterious. > > When I boot my computer with printer turned on and load ulpt driver > the results is like above (ugens instead of ulpt). > > When I turn off the printer, the kernel reads: > > ugen0: at uhub0 port 2 (addr 2) disconnected > All threads purged from ugen0.2 > All threads purged from ugen0.1 > All threads purged from ugen0 > ugen0: detached > > and ugen0, ugen0.1, and ugen0.2 disappear in /dev. > > When I turn on the printer again with ulpt loaded, the kernel reads: > > ulpt0: Canon iP2000, rev 1.10/1.05, addr 2, iclass 7/1 > ulpt0: using bi-directional mode > > And I have ulpt0 and unlpt0 desired in /dev instead of ugens now! > > May be the ugen driver built in kernel prevents ulpt driver from > proper work and I should throw ugen driver out from kernel? > No instead just have ulpt compiled statically in or load it by /boot/loader.conf (or do what you did here.) Vince _______________________________________________ > freebsd-questions@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4577F9EE.5020203>