Date: Thu, 10 Feb 2000 10:50:07 +0000 From: "Paul J. Vickers" <paul.vickers@barclays.co.uk> To: smp@FreeBSD.org Subject: ASUS Message-ID: <38A297DF.F27B267D@barclays.co.uk>
next in thread | raw e-mail | index | archive | help
I'm trying to get FreeBSD 3.4 up on an ASUS P2L97-DS. It boots Ok and
runs for a while, then stops dead ??
I enclose the mptable and dmesg out put
MPTable, version 2.0.15
-------------------------------------------------------------------------------
MP Floating Pointer Structure:
location: BIOS
physical address: 0x000f6e30
signature: '_MP_'
length: 16 bytes
version: 1.4
checksum: 0x05
mode: Virtual Wire
-------------------------------------------------------------------------------
MP Config Table Header:
physical address: 0x000f6a22
signature: 'PCMP'
base table length: 268
version: 1.4
checksum: 0x97
OEM ID: 'OEM00000'
Product ID: 'PROD00000000'
OEM table pointer: 0x00000000
OEM table size: 0
entry count: 25
local APIC address: 0xfee00000
extended table length: 124
extended table checksum: 184
-------------------------------------------------------------------------------
MP Config Base Table Entries:
--
Processors: APIC ID Version State Family Model Step
Flags
1 0x11 BSP, usable 6 3 4
0x80fbff
0 0x11 AP, usable 6 3 4
0x80fbff
--
Bus: Bus ID Type
0 PCI
1 PCI
2 ISA
--
I/O APICs: APIC ID Version State Address
2 0x11 usable 0xfec00000
--
I/O Ints: Type Polarity Trigger Bus ID IRQ APIC ID
PIN#
ExtINT conforms conforms 2 0
2 0
INT conforms conforms 2 1
2 1
INT conforms conforms 2 0
2 2
INT conforms conforms 2 3
2 3
INT conforms conforms 2 4
2 4
INT conforms conforms 2 6
2 6
INT conforms conforms 2 7
2 7
INT conforms conforms 2 8
2 8
INT conforms conforms 2 9
2 9
INT conforms conforms 2 12
2 12
INT conforms conforms 2 14
2 14
INT conforms conforms 2 15
2 15
INT active-lo level 1 0:A
2 16
INT active-lo level 0 4:D
2 19
INT active-lo level 0 9:A
2 19
INT active-lo level 0 10:A
2 18
INT active-lo level 0 11:A
2 17
--
Local Ints: Type Polarity Trigger Bus ID IRQ APIC ID
PIN#
ExtINT active-hi edge 2 0
255 0
NMI active-hi edge 2 0
255 1
-------------------------------------------------------------------------------
MP Config Extended Table Entries:
--
bus ID: 0 address type: I/O address
address base: 0x0
address range: 0x10000
--
bus ID: 0 address type: memory address
address base: 0x8000000
address range: 0xdae80000
--
bus ID: 0 address type: prefetch address
address base: 0xe2e80000
address range: 0x5180000
--
bus ID: 0 address type: memory address
address base: 0xe8000000
address range: 0x18000000
--
bus ID: 0 address type: memory address
address base: 0xa0000
address range: 0x20000
--
bus ID: 2 bus info: 0x01 parent bus ID: 0--
bus ID: 0 address modifier: add
predefined range: 0x00000000--
bus ID: 0 address modifier: add
predefined range: 0x00000001
-------------------------------------------------------------------------------
# SMP kernel config file options:
# Required:
options SMP # Symmetric MultiProcessor
Kernel
options APIC_IO # Symmetric (APIC) I/O
# Optional (built-in defaults will work in most cases):
options NCPU=2 # number of CPUs
options NBUS=3 # number of busses
options NAPIC=1 # number of IO APICs
options NINTR=24 # number of INTs
===============================================================================
Copyright (c) 1992-1999 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights
reserved.
FreeBSD 3.4-RELEASE #2: Wed Feb 9 16:45:08 GMT 2000
root@erin.ipv6.stedman.co.uk:/usr/kame/freebsd3/sys/compile/IPV6
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II (686-class CPU)
Origin = "GenuineIntel" Id = 0x634 Stepping = 4
Features=0x80fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,MMX>
real memory = 134217728 (131072K bytes)
avail memory = 126832640 (123860K bytes)
Programming 24 pins in IOAPIC #0
FreeBSD/SMP: Multiprocessor motherboard
cpu0 (BSP): apic id: 1, version: 0x00040011, at 0xfee00000
cpu1 (AP): apic id: 0, version: 0x00040011, at 0xfee00000
io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000
Preloaded elf kernel "kernel" at 0xc037b000.
Pentium Pro MTRR support enabled
altq: major number is 96
Probing for devices on PCI bus 0:
chip0: <Intel 82443LX host to PCI bridge> rev 0x03 on pci0.0.0
chip1: <Intel 82443LX PCI-PCI bridge> rev 0x03 on pci0.1.0
chip2: <Intel 82371AB PCI to ISA bridge> rev 0x01 on pci0.4.0
ide_pci0: <Intel PIIX4 Bus-master IDE controller> rev 0x01 on pci0.4.1
chip3: <Intel 82371AB Power management controller> rev 0x01 on pci0.4.3
ahc0: <Adaptec 2940 Ultra SCSI adapter> rev 0x00 int a irq 19 on
pci0.9.0
ahc0: aic7880 Wide Channel A, SCSI Id=7, 16/255 SCBs
pn0: <82c169 PNIC 10/100BaseTX> rev 0x21 int a irq 18 on pci0.10.0
pn0: Ethernet address: 00:a0:cc:39:e7:8a
pn0: autoneg complete, link status good (full-duplex, 100Mbps)
pn0: supplying EUI64: 00:a0:cc:ff:fe:39:e7:8a
de0: <Digital 21140 Fast Ethernet> rev 0x12 int a irq 17 on pci0.11.0
de0: DEC DE500-XA 21140 [10-100Mb/s] pass 1.2
de0: address 00:00:f8:30:65:41
Probing for devices on PCI bus 1:
vga0: <Matrox model 1001 graphics accelerator> rev 0x02 int a irq 16 on
pci1.0.0
Probing for PnP devices:
Probing for devices on the ISA bus:
sc0 on isa
sc0: VGA color <16 virtual consoles, flags=0x0>
atkbdc0 at 0x60-0x6f on motherboard
atkbd0 irq 1 on isa
psm0 irq 12 on isa
psm0: model Generic PS/2 mouse, device ID 0
sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa
sio0: type 16550A
sio1 at 0x2f8-0x2ff irq 3 on isa
sio1: type 16550A
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (wd0): <IBM-DTTA-351010>
wd0: 9671MB (19807200 sectors), 19650 cyls, 16 heads, 63 S/T, 512 B/S
wdc1 at 0x170-0x177 irq 15 on isa
wdc1: unit 0 (atapi): <ASUS CD-S340/V1.71>, removable, accel, dma, iordy
acd0: drive speed 1031 - 5843KB/sec, 128KB cache
acd0: supported read types: CD-R, CD-RW, CD-DA, packet track
acd0: Audio: play, 255 volume levels
acd0: Mechanism: ejectable tray
acd0: Medium: CD-ROM 120mm data disc loaded, unlocked
wdc1: unit 1 (atapi): <IOMEGA ZIP 100 ATAPI/23.D>, removable,
intr, iordis
wfd0: medium type unknown (no disk)
wfd0: buggy Zip drive, 64-block transfer limit set
ppc0 at 0x378 irq 7 flags 0x40 on isa
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/9 bytes threshold
lpt0: <generic printer> on ppbus 0
lpt0: Interrupt-driven port
ppi0: <generic parallel i/o> on ppbus 0
plip0: <PLIP network interface> on ppbus 0
vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa
npx0 on motherboard
npx0: INT 16 interface
APIC_IO: Testing 8254 interrupt delivery
APIC_IO: routing 8254 via pin 2
IPsec: Initialized Security Association Processing.
Waiting 2 seconds for SCSI devices to settle
SMP: AP CPU #1 Launched!
de0: enabling 10baseT port
sa0 at ahc0 bus 0 target 2 lun 0
sa0: <HP C1533A A708> Removable Sequential Access SCSI-2 device
sa0: 10.000MB/s transfers (10.000MHz, offset 15)
sa1 at ahc0 bus 0 target 5 lun 0
sa1: <EXABYTE EXB-8500SMBANXH1 0458> Removable Sequential Access SCSI-2
device
sa1: 4.032MB/s transfers (4.032MHz, offset 11)
Internet communications are not secure and therefore the Barclays Group does
not accept legal responsibility for the contents of this message. Any views
or opinions presented are solely those of the author and do not necessarily
represent those of the Barclays Group.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-smp" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?38A297DF.F27B267D>