Date: Wed, 17 Sep 2003 10:21:55 -0500 From: "Charles Howse" <chowse@charter.net> To: "'Ekrem'" <ekrem@ozemail.com.au> Cc: 'freebsd-questions' <freebsd-questions@freebsd.org> Subject: RE: Boot timeout? Message-ID: <003701c37d2f$6e266210$04fea8c0@moe> In-Reply-To: <1063811857.597.67.camel@beynam.ecko.net.au>
next in thread | previous in thread | raw e-mail | index | archive | help
> On Wed, 2003-09-17 at 05:47, Charles Howse wrote: > > > > Now the system hangs for about 20 seconds at the BIOS drive=20 > > > detection, > > > > and at the FBSD atapi controller detection. > > >=20 > > > Are you using ATAPICAM? If so, it's probably the SCSI settling. > > > That's adjustable in the kernel configuration. > >=20 > > The string 'atapicam' does not appear in my > > /usr/src/sys/i386/conf/CUSTOM customized kernel config=20 > file. Is that > > what you meant? I did find that string in LINT, but I'm=20 > not using it. > >=20 > > I may have misled you in my post. What I should have said is, the > > system hangs for about 20 seconds at the BIOS drive=20 > detection, and then > > there is another 20 second delay when FBSD is detecting=20 > devices, *after* > > it displays the line about finding the atapi controller. =20 > It displays > > that line concerning the atapi controller, issues 2 cr/lf=20 > and pauses for > > that 20 seconds. It then continues to load without error,=20 > all devices > > are detected properly and I can read and write to them. > >=20 > > I really think this delay may be more related to hardware=20 > than software. > > I just booted the system to an MS-DOS diskette, and the=20 > delay is still > > there. I have no special settings in BIOS. > >=20 > > BTW: I've also posted this to alt.comp.hardware. No joy yet. >=20 > Hi, >=20 > I also think the delay is hardware related. The most common=20 > reason would > be if a drive was jumpered incorrectly, eg. if the drive is=20 > set as slave > but there is no master drive, or the master drive is set with slave > drive present when there is no slave drive. >=20 > So the BIOS waits for a response from an unavailable drive or=20 > until the > time-out period is reached. >=20 > In your original post you mentioned the 2Gb was set as=20 > master, then you > connected it as secondary-slave. You would need to change jumper > settings to reflect this. Yes, I changed the jumper. I will check the Western Digital (I HATE them) web site for up-to-date info on jumper settings for that drive, and try different settings myself, but I think I have it correct to begin with. The key on the drive itself says to set it this way for master: ::::. ^ Where . Is the key pin, so you don't get it upside down.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?003701c37d2f$6e266210$04fea8c0>