Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 16 May 2008 19:46:01 -0500
From:      Thomas Simpson <toms@chirock.com>
To:        Mark Busby <redtick@sbcglobal.net>
Cc:        help help <freebsd-questions@freebsd.org>
Subject:   Re: 486 Install??
Message-ID:  <482E2AC9.5070507@chirock.com>
In-Reply-To: <704507.287.qm@web81204.mail.mud.yahoo.com>
References:  <704507.287.qm@web81204.mail.mud.yahoo.com>

next in thread | previous in thread | raw e-mail | index | archive | help
Thanks to all who sent me messages.

I think I see where to go, should I need to turn to a FreeBSD.

Tom Simpson

Mark Busby wrote:
> Could you do the job with a stripped down system? Like freenas, 
> monowall, nanobsd or tinybsd. All based on the bsd system, and with a 
> little work you can add all the needed ports. Boot from the cd-rom, 
> save config to floppy or usb thumb drive, use all the harddrive for 
> storage.
> I've been looking into this. If I could just find a boot loader that 
> would give a usb thumb drive boot as an option.
>
> */Thomas F Simpson Jr <toms@chirock.com>/* wrote:
>
>     I have a 486 DEEP GREEN system I would like to put some version of
>     FreeBSD on (I have my reasons).
>
>     I have other inquiries out on this, but if I correctly recall (and
>     that is a real rusty recall at best), the max memory you could get
>     on one of these beasts was 48MB, unless they made some bigger,
>     recognizable, 72-pin modules.
>
>     I have 8 MB of hard drive space free for a FreeBSD partition and I
>     am actually running an Intel P24T Overdrive for my CPU. All work
>     fine on the DOS 6.2.2 partition I need to run.
>
>     Would any version of FreeBSD work with just 48MB of RAM? Or do I
>     need to figure out a way to get more RAM on the board, IF POSSIBLE?
>
>     Thanks.
>
>     Tom Simpson
>     Omaha, NE
>     toms@chirock.com
>     402.896.1157
>
>
>
>     _______________________________________________
>     freebsd-questions@freebsd.org mailing list
>     http://lists.freebsd.org/mailman/listinfo/freebsd-questions
>     To unsubscribe, send any mail to
>     "freebsd-questions-unsubscribe@freebsd.org"
>
>



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?482E2AC9.5070507>