Date: Wed, 15 Nov 2000 14:30:06 -0600 From: "McKinley, Rob" <RMcKinley@mercantec.com> To: "'freebsd-alpha@freebsd.org'" <freebsd-alpha@FreeBSD.ORG> Subject: RE: AS200, PC164 Success. Message-ID: <C0276A99F75AD41188950008C7B989FF088B3B@nt01.merc.local>
next in thread | raw e-mail | index | archive | help
> -----Original Message-----
> From: Matthew Jacob [mailto:mjacob@feral.com]
> Sent: Tuesday, November 14, 2000 10:39 AM
> To: McKinley, Rob
> Cc: 'freebsd-alpha@freebsd.org'
> Subject: RE: AS200, PC164 Success.
>
>
> On Tue, 14 Nov 2000, McKinley, Rob wrote:
>
> > It's the standard Symbios (810?) adapter. Let me know if you need more
> > info.
>
> Not the same PR then (whew).
>
> If you have any dmesg output that might correlate, that would be of
> inestimable help.
>
> -matt
>
Matt, et al.,
Dmesg output below is from the resulting installed system. I need to pick
up a working serial cable this evening to boot it from a console to get the
boot messages when booting off the CDROM/floppies. The CDROM is a Plextor
12x SCSI. I double checked termination on the scsi chain and all seems well
there. I did note that after a buildworld, when I shut it down a show dev
at the SRM prompt only showed the hard drive, no CDROM, even though I had
the CDROM mounted during the buildworld. My guess at this point is that
during the beginning of sysinstall (and possibly during normal running), the
CDROM device is getting dropped as a valid device (similar to the thread
about the AS1200 getting read errors on the hard drive early on in boot
sequence?).
The SRM is the updated version from the Tru64 5.0 kit, so I could try moving
it back a rev or two.
As an aside, if I leave the Tru64 5 disk on the chain I get the dreaded
"going nowhere without my init" panic.
***************** Start of AS200/233 dmesg *************************
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.2-RC1 #0: Thu Nov 9 10:37:30 GMT 2000
root@rawhide.osd.bsdi.com:/usr/src/sys/compile/GENERIC
AlphaStation 200/400 ("Avanti")
AlphaStation 200 4/233, 233MHz
8192 byte page size, 1 processor.
CPU: EV45 (21064A) major=6 minor=0
OSF PAL rev: 0x100000002012e
real memory = 148930560 (145440K bytes)
avail memory = 138436608 (135192K bytes)
Preloaded elf kernel "kernel" at 0xfffffc0000764000.
md0: Malloc disk
pci0: <PCI bus> on pcib0
sym0: <810> port 0x10000-0x100ff mem 0x82810000-0x828100ff irq 11 at device
6.0 on pci0
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: interrupting at ISA irq 11
isab0: <Intel 82378IB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
de0: <Digital 21040 Ethernet> port 0x10100-0x1017f mem 0x82810100-0x8281017f
irq 5 at device 11.0 on pci0
de0: interrupting at ISA irq 5
de0: DEC 21040 [10Mb/s] pass 2.4
de0: address 00:00:f8:20:60:e2
pci0: <S3 Trio graphics accelerator> at 13.0 irq 10
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: interrupting at ISA irq 6
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
atkbd0: interrupting at ISA irq 1
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: interrupting at ISA irq 12
psm0: model MouseMan+, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A
sio0: interrupting at ISA irq 4
sio1: reserved for low-level i/o
ppc0: <Parallel port> at port 0x3bc-0x3bf irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
plip0: cannot reserve interrupt, failed.
lpt0: <Printer> on ppbus0
lpt0: Polled port
ppi0: <Parallel I/O> on ppbus0
ppc0: interrupting at ISA irq 7
Timecounter "alpha" frequency 233319268 Hz
Waiting 15 seconds for SCSI devices to settle
de0: enabling 10baseT port
Mounting root from ufs:/dev/da0a
da0 at sym0 bus 0 target 4 lun 0
da0: <CONNER CFP2107E 2.14GB 1527> Fixed Direct Access SCSI-2 device
da0: 10.000MB/s transfers (10.000MHz, offset 8)
da0: 2048MB (4194304 512 byte sectors: 255H 63S/T 261C)
cd0 at sym0 bus 0 target 2 lun 0
cd0: <PLEXTOR CD-ROM PX-12TS 1.02> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: Attempt to query device size failed: NOT READY, Medium not present
cd9660: RockRidge Extension
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?C0276A99F75AD41188950008C7B989FF088B3B>