Date: Sat, 19 Jun 2004 21:31:21 +0200 From: Andreas Braukmann <braukmann@tse-online.de> To: Bill Paul <wpaul@FreeBSD.ORG> Cc: freebsd-current@freebsd.org Subject: Re: Realtek RT8139 (onboard) - failed to receive packet in loopback mode Message-ID: <247940000.1087673481@cage.int.unixxinu.de> In-Reply-To: <20040618173204.3DE7816A4D2@hub.freebsd.org> References: <20040618173204.3DE7816A4D2@hub.freebsd.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On 06/18/04 17:32:04 +0000 Bill Paul wrote: >> On 06/18/04 01:51:17 +0000 Bill Paul wrote: >> > Please try the code located at: >> > >> > http://www.freebsd.org/~wpaul/re [...] > Heh. You were able to trivally patch if_re.c but not if_rlreg.h? :) I refuse any further comments on this ;-) > I uploaded a new copy and diff of if_rlreg.h to the same URL. Please > try again. thanks. The module compiles fine now and probes the nics successfully: gate# kldload ./if_re.ko re0: <RealTek 8139C+ 10/100BaseTX> port 0xdc00-0xdcff mem 0xe3400000-0xe34000ff irq 11 at device 9.0 on pci0 re0: Ethernet address: 00:90:fb:04:1b:31 re0: [GIANT-LOCKED] [... re1, re2, re3, re4 ...] The appendant PHY: miibus0: <MII bus> on re0 rlphy0: <RealTek internal media interface> on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto ifconfig still gives no info about the media types: gate# ifconfig re0 re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500 options=1b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING> ether 00:90:fb:04:1b:31 media: Ethernet autoselect (none) The original driver v 1.24 with the (deactivated) old diagnostic code works quite ok (despite of teh misleading / missing ifconfig output for the media). The patched driver from your driver doesn't work anymore; all attempts to send or receive packets fail. Currently I can't tell you anything about the concrete link state of the interface. The box and the (unmanaged) switch are 36 km away from here. It's possible, that I get there tomorrow or on monday at the latest. If you need any further information beforehand, just tell me ... -Andreas
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?247940000.1087673481>