Date: 01 Feb 2002 11:37:32 -0600 From: "Kirk R. Wythers" <kwythers@forestry.umn.edu> To: freebsd-questions@FreeBSD.org Subject: my hardware not listed in userconfig menue Message-ID: <1012585052.2038.24.camel@lorax.forestry.umn.edu>
next in thread | raw e-mail | index | archive | help
I need some advice concerning the userconfig menue. After going into the visual mode kernel config menue I see several conflicts. However, very little of my hardware is listed. For example my adaptec 7890 scsi controller is not listed (instead I see adaptec 154x and 152x), neither is my 3com 905b network card. I am a little nervous about removing all the network cards that are conflicting without leaving one of them (even though it may not be the card on my system). Same issue with the scsi controller. There are no conflicts, but neither of the adaptec cards is the 7890 that is on my system. Should I remove, not leaving a scsi controller? or should I leave alone even though neither is my card? and hope that my hardware is found later in the install process... Any advice would be much appreciated... Kirk -- Kirk R. Wythers University of Minnesota Tel: 612.625.2261 Department of Forest Resources Fax: 612.625.5212 1530 Cleveland Ave. N. Email: kwythers@forestry.umn.edu Saint Paul, MN 55108 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?1012585052.2038.24.camel>