Date: Mon, 09 Aug 1999 15:07:43 +0300 From: "Andy V. Oleynik" <andyo@prime.net.ua> To: Vadim Stanovov <vvs@blpk.ru> Cc: "freebsd-questions@FreeBSD.ORG" <freebsd-questions@FreeBSD.ORG> Subject: Re: irq4 not in bitmap of probed irqs0 Message-ID: <37AEC48E.ABCFE3D6@prime.net.ua> References: <37AE8BFB.5ABB4DE3@blpk.ru>
next in thread | previous in thread | raw e-mail | index | archive | help
I think it would be helpfull to look in the BIOS setup. Probably U should configure ur PCI/ISA configuration so that IRQ4/IRQ3 would be assigned ISA. Vadim Stanovov wrote: > Hi, > > I get the boot problem: > > sio0: configured irq 4 not in bitmap of probed irqs0 > sio0: at 0x3f8-0x3ff irq 4 on isa > sio0: type 16550A > > after that system hung up, only hard reset helps restart it. > If disable sio0 in boot config or kernel configuration everything looks > fine, but I need this port. In DOS both sio ports work good. > > Hardware configuration - ALR-MP P133/512K cashe/64M RAM > > eisa0: <ALR301 (System Board)> > Probing for devices on the EISA bus > Probing for devices on PCI bus 0: > chip0: <Intel 82434NX (Neptune) PCI cache memorycontroller> rev 0x11 on > pci0.0.0 > chip1: <Intel 82375EB PCI-EISA bridge> rev 0x05 on pci0.2.0 > xl0: <3Com 3c905B-TX Fast Etherlink XL> rev 0x30 int a irq 10 on > pci0.13.0 > ahc0: <Adaptec 2940 Ultra SCSI adapter> rev 0x00 int a irq 11 on > pci0.14.0 > vga0: <S3 Trio graphics accelerator> rev 0x00 int a irq 9 on pci0.15.0 > > Is there any ideas? > > Thanks, > > Vadim Stanovov > > E-mail: mailto:vvs@blpk.ru > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-questions" in the body of the message -- WBW Andy V. Oleynik (When U work in virtual office prime.net.ua's U have good chance to obtain system administrator virtual money ö%-) +380442448363 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?37AEC48E.ABCFE3D6>