Date: Mon, 20 Apr 2015 12:59:37 +0430 From: Mohammad BadieZadegan <mbzadegan@gmail.com> To: freebsd-wireless@freebsd.org Subject: Re: Broadcom BCM4318 Message-ID: <CADMcpTYsALWcQSHb0H7Lc_iG4yLKfNKAFzO44kQP7_EdPtNBiA@mail.gmail.com> In-Reply-To: <20150420074241.GA3000@c720-r276659> References: <CADMcpTY3hkTfP2zJ0vb-QZo5Qof1mDFsWfuTb60xcjiEC%2BXfOw@mail.gmail.com> <20150420074241.GA3000@c720-r276659>
next in thread | previous in thread | raw e-mail | index | archive | help
Yes, When I run this daemon for my SSID: Successfully initialized wpa_supplicant wlan0: Trying to associate with 14:cc:20:79:0c:35 (SSID=3D'Saman 4' freq=3D= 2462 MHz) wlan0: Authentication with 14:cc:20:79:0c:35 timed out. wlan0: CTRL-EVENT-DISCONNECTED bssid=3D14:cc:20:79:0c:35 reason=3D3 locally_generated=3D1 wlan0: Trying to associate with 14:cc:20:79:0c:35 (SSID=3D'Saman 4' freq=3D= 2462 MHz) wlan0: Authentication with 14:cc:20:79:0c:35 timed out. wlan0: CTRL-EVENT-DISCONNECTED bssid=3D14:cc:20:79:0c:35 reason=3D3 locally_generated=3D1 wlan0: Trying to associate with 14:cc:20:79:0c:35 (SSID=3D'Saman 4' freq=3D= 2462 MHz) ^Cwlan0: CTRL-EVENT-DISCONNECTED bssid=3D14:cc:20:79:0c:35 reason=3D3 locally_generated=3D1 ioctl[SIOCS80211, op=3D26, val=3D0, arg_len=3D0]: Operation not supported wlan0: CTRL-EVENT-TERMINATING On Mon, Apr 20, 2015 at 12:12 PM, Matthias Apitz <guru@unixarea.de> wrote: > El d=C3=ADa Monday, April 20, 2015 a las 12:04:43PM +0430, Mohammad > BadieZadegan escribi=C3=B3: > > > Dear Felix Friedlander, > > Thanks for following my issue. > > I copied and reinstall your new bwn-kmod-firmware (0.2.0). > > I think that my state is better than but still I do not get any IP. > > PS: My WiFi LED turned on but it has not get any IP address. > > > > ************** My dmesg *********** > > siba_bwn0: <Broadcom BCM4318 802.11b/g Wireless> mem > 0xd0204000-0xd0205fff > > irq 20 at device 2.0 on pci5 > > bwn0 on siba_bwn0 > > bwn0: WLAN (chipid 0x4318 rev 9) PHY (analog 3 type 2 rev 7) RADIO (man= uf > > 0x17f ver 0x2050 rev 8) > > bwn0: DMA (32 bits) > > bwn0: firmware version (rev 666 patch 2 date 0xb217 time 0x9e7) > > bwn0: warn: firmware state (0) > > bwn0: warn: firmware state (0) > > bwn0: warn: firmware state (0) > > bwn0: warn: firmware state (0) > > > > ************** My ifconfig ************ > > bwn0: flags=3D8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu > 2290 > > ether 00:14:a5:63:39:e5 > > nd6 options=3D29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> > > media: IEEE 802.11 Wireless Ethernet autoselect mode 11g > > status: associated > > wlan0: flags=3D8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mt= u > 1500 > > ether 00:14:a5:63:39:e5 > > nd6 options=3D29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> > > media: IEEE 802.11 Wireless Ethernet autoselect (autoselect) > > status: no carrier > > ssid "" channel 4 (2427 MHz 11g) > > country US authmode WPA2/802.11i privacy ON deftxkey UNDEF txpower = 30 > > bmiss 7 scanvalid 60 bgscan bgscanintvl 300 bgscanidle 250 roam:rss= i > 7 > > roam:rate 5 protmode CTS wme roaming MANUAL > > ********************************************** > > The interface wlan0 is not associated with any AP (and so it can not get > any IP addr). Do you run wpa_supplicant(8) daemon with a correct > configuration matching your air radio APs? > > Btw: Please, do not top post and trim your replies. > > matthias > > > -- > Matthias Apitz, guru@unixarea.de, http://www.unixarea.de/ > +49-170-4527211 +49-176-38902045 > "Wenn der Mensch von den Umst=C3=A4nden gebildet wird, so mu=C3=9F man di= e Umst=C3=A4nde > menschlich bilden." > "Si el hombre es formado por las circunstancias entonces es necesario > formar humanamente > las circunstancias", Karl Marx in Die heilige Familie / La sagrada famili= a > (MEW 2, 138) > --=20 <http://ir.linkedin.com/in/xadegan>;
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?CADMcpTYsALWcQSHb0H7Lc_iG4yLKfNKAFzO44kQP7_EdPtNBiA>