Date: Fri, 12 Jan 2001 09:50:27 -0600 From: Jeremy Vandenhouten <jeremy.vandenhouten@marquette.edu> To: Michael Bretterklieber <mbretter@inode.at>, hardware@freebsd.org Subject: Re: Athlon Thunderbird 700 w. Asus K7M Motherboard vs FreeBSD 4.2 Message-ID: <5220405270e0.5270e0522040@marquette.edu>
next in thread | raw e-mail | index | archive | help
Interestingly you also have this: pci0: <unknown card> (vendor=0x109e, dev=0x0878) at 14.1 irq 5 While it wouldn't seem that this would cause all your problems, but it might be a start. Also unless you have 2 video cards there's something wrong as well: vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 pci1: <NVidia Riva Ultra Vanta TNT2 graphics accelerator> at 5.0 irq 11 Sorry I couldn't help more, but it's a start... ----- Original Message ----- From: Michael Bretterklieber <mbretter@inode.at> Date: Friday, January 12, 2001 9:15 am Subject: Athlon Thunderbird 700 w. Asus K7M Motherboard vs FreeBSD 4.2 > Hi, > > I have problems with my Athlon Thunderbird 700 on an Asus K7M > Motherboard > (Bios 1009) and FreeBSD 4.2. > The system is very very slow, like on an old 386. I have this > problems since I updatet from an Athlon 500 to this Athlon > Thunderbird 700. I > have on the same Harddisk Win98 and Win2K and they work without > problems, fast and stable. > This situation is disastrous for me, because I had to work under > FreeBSD, so I hope, that somebody can help. > > I tried the Generic-Kernel and my own Kernel-config, but the > result was > > the same. > kernel output: > Copyright (c) 1992-2000 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, > 1994 > > The Regents of the University of California. All rights reserved. > FreeBSD 4.2-RELEASE #1: Sat Dec 2 21:47:42 CET 2000 > root@worf.jawa.at:/usr/src/sys/compile/WORF > Timecounter "i8254" frequency 1193182 Hz > CPU: AMD Athlon(tm) Processor (704.94-MHz 686-class CPU) > Origin = "AuthenticAMD" Id = 0x642 Stepping = 2 > > > Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,C MOV,PAT,PSE36,MMX,FXSR> > > > AMD Features=0xc0440000<<b18>,AMIE,DSP,3DNow!> > real memory = 134152192 (131008K bytes) > config> q > avail memory = 127262720 (124280K bytes) > Preloaded elf kernel "kernel" at 0xc0354000. > Preloaded userconfig_script "/boot/kernel.conf" at 0xc035409c. > Pentium Pro MTRR support enabled > npx0: <math processor> on motherboard > npx0: INT 16 interface > pcib0: <AMD-751 host to PCI bridge> on motherboard > pci0: <PCI bus> on pcib0 > pcib1: <AMD-751 PCI-PCI (AGP) bridge> at device 1.0 on pci0 > pci1: <PCI bus> on pcib1 > pci1: <NVidia Riva Ultra Vanta TNT2 graphics accelerator> at 5.0 > irq 11 > > isab0: <VIA 82C686 PCI-ISA bridge> at device 4.0 on pci0 > isa0: <ISA bus> on isab0 > atapci0: <VIA 82C686 ATA66 controller> port 0xffa0-0xffaf at > device 4.1 > > on pci0 > ata0: at 0x1f0 irq 14 on atapci0 > ata1: at 0x170 irq 15 on atapci0 > pci0: <VIA 83C572 USB controller> at 4.2 irq 9 > chip1: <VIA 82C686 ACPI interface> at device 4.4 on pci0 > pcm0: <VIA VT82C686A AC'97 Audio> port 0xd000-0xd003,0xd400- > 0xd4ff irq > 10 at device 4.5 on pci0 > bktr0: <BrookTree 878> mem 0xeddfd000-0xeddfdfff irq 5 at device 14.0 > on > pci0 > iicbb0: <I2C generic bit-banging driver> on bti2c0 > iicbus0: <Philips I2C bus> on iicbb0 master-only > smbus0: <System Management Bus> on bti2c0 > bktr0: Card has no configuration EEPROM. Cannot determine card make. > bktr0: Pinnacle/Miro TV, Temic NTSC tuner. > pci0: <unknown card> (vendor=0x109e, dev=0x0878) at 14.1 irq 5 > sym0: <810a> port 0xd800-0xd8ff mem 0xefffff00-0xefffffff irq 10 at > device 15.0 on pci0 > sym0: Symbios NVRAM, ID 7, Fast-10, SE, parity checking > sym0: open drain IRQ line driver > sym0: using LOAD/STORE-based firmware. > de0: <Digital 21041 Ethernet> port 0xc800-0xc87f mem > 0xeffffe80-0xeffffeff irq 9 at device 16.0 on pci0 > de0: SMC 21041 [10Mb/s] pass 1.1 > de0: address 00:00:c0:99:b5:bf > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on > isa0 > fdc0: FIFO enabled, 8 bytes threshold > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 > kbd0 at atkbd0 > psm0: <PS/2 Mouse> irq 12 on atkbdc0 > psm0: model Generic PS/2 mouse, device ID 0 > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on > isa0 > sc0: <System console> at flags 0x100 on isa0 > sc0: VGA <16 virtual consoles, flags=0x300> > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > sio0: type 16550A > sio1: configured irq 3 not in bitmap of probed irqs 0 > ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 > ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode > ppc0: FIFO with 16/16/8 bytes threshold > ppbus0: IEEE1284 device found /NIBBLE/PS2/ECP > Probing for PnP devices on ppbus0: > ppbus0: <HEWLETT-PACKARD DESKJET 890C> PCL,MLC,PML > lpt0: <Printer> on ppbus0 > lpt0: Interrupt-driven port > plip0: <PLIP network interface> on ppbus0 > ppi0: <Parallel I/O> on ppbus0 > joy0 at port 0x201 on isa0 > de0: enabling 10baseT port > ad0: 29314MB <IBM-DTLA-307030> [59560/16/63] at ata0-master UDMA66 > ad2: 9641MB <IBM-DTTA-371010> [19590/16/63] at ata1-master UDMA33 > ad3: 6197MB <IBM-DHEA-36481> [12592/16/63] at ata1-slave UDMA33 > Waiting 5 seconds for SCSI devices to settle > (noperiph:sym0:0:-1:-1): SCSI BUS reset delivered. > (probe5:sym0:0:5:0): phase change 6-7 6@07e2ef8c resid=4. > Mounting root from ufs:/de cd0 at sym0 bus 0 target 4 lun 0 > cd0: <PLEXTOR CD-R PX-W8220T 1.01> Removable CD-ROM SCSI-2 device > cd0: 10.000MB/s transfers (10.000MHz, offset 8) > cd0: Attempt to query device size failed: NOT READY, Medium not > present > - tray closed > da0 at sym0 bus 0 target 5 lun 0 > da0: <IOMEGA ZIP 100 D.09> Removable Direct Access SCSI-2 device > da0: 3.300MB/s transfers > da0: Attempt to query device size failed: NOT READY, Medium not > present > uhci0: <VIA 83C572 USB controller> port 0xcc00-0xcc1f irq 9 at device > 4.2 on pci0 > usb0: <VIA 83C572 USB controller> on uhci0 > usb0: USB revision 1.0 > uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub0: 2 ports with 2 removable, self powered > > bye, > -- > -------------------------------------- > E-mail: Michael.Bretterklieber@jawa.at > ---------------------------- > JAWA MANAGEMENT und SOFTWARE > Liebenauer Hauptstr. 200 > A-8041 GRAZ > Tel: ++43-(0)316-403274-12 > Fax: ++43-(0)316-403274-10 > GSM: ++43-(0)676-93 96 698 > homepage: http://www.jawa.at > --------- privat ----------- > E-mail: mbretter@inode.at > homepage: http://www.inode.at/mbretter > -------------------------------------- > > > > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-hardware" in the body of the message > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-hardware" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?5220405270e0.5270e0522040>