Date: Tue, 13 Jun 2000 10:55:43 +0400 (MSD) From: vova@express.ru To: Nick Hibma <n_hibma@calcaphon.com> Cc: mobile@freebsd.org, hadware@freebsd.org Subject: Re: SONY Z505S Message-ID: <Pine.BSF.4.21.0006131049470.47610-100000@lanturn.kmost.express.ru> In-Reply-To: <Pine.BSF.4.20.0006091411480.11031-100000@localhost>
next in thread | previous in thread | raw e-mail | index | archive | help
On Fri, 9 Jun 2000, Nick Hibma wrote: It seems audio for my notebook broken under 5.0-CURRENT :( I've got pcm0: <NeoMagic 256AV> mem 0xfea00000-0xfeafffff,0xfe000000-0xfe3fffff irq 9 at device 8.1 on pci0 while booting # cat /dev/sndstat FreeBSD Audio Driver (newpcm) Jun 7 2000 19:11:52 Installed devices: pcm0: <NeoMagic 256AV> at memory 0xfe000000, 0xfea00000 irq 9 (1p/1r channels duplex) and all seems to work while I don't try to play something, speakers play some tacts and then replay these tacs again and again. This right for /dev/dsp or for /dev/audio. Very short .au files plays good, but long :( Any ideas ? pcm0 work well on 4.0 and was broken after upgrade. > > I've got subj. > > > > Successfuly runs: > > Vidio > > Audio > > Intell EtherExpress > > Serial Port > > Parralel Port > > USB Hub > > PCCard slot (atapi cdrom or sio2 in my case) > > > > What don't work: > > Rockwell HCF 56K Speakerphone PCI Modem (by win 0x2f8 irq 9) WinModem ? > > USB Floppy drive > > IR port (by BIOS: address 3E8 irq 10 DMA 0 FIR base address 140) > > 1394 Bus Controller > > > > Any suggestions ? > > May be anybody run IR port or USB floppy ? > > > > ==========[ boot dmesg ]================================================== > > > > CPU: Pentium II/Pentium II Xeon/Celeron (331.58-MHz 686-class CPU) > > Origin = "GenuineIntel" Id = 0x66a Stepping = 10 > > Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR> > > real memory = 67043328 (65472K bytes) > > config> q > > Preloaded elf kernel "kernel" at 0xc038b000. > > Preloaded userconfig_script "/boot/kernel.conf" at 0xc038b0a8. > > ccd0-3: Concatenated disk drivers > > Pentium Pro MTRR support enabled > > md0: Malloc disk > > npx0: <math processor> on motherboard > > npx0: INT 16 interface > > apm0: <APM BIOS> on motherboard > > apm: found APM BIOS v1.2, connected at v1.2 > > pcib0: <Intel 82443BX host to PCI bridge (AGP disabled)> on motherboard > > pci0: <PCI bus> on pcib0 > > fxp0: <Intel EtherExpress Pro 10/100B Ethernet> port 0xfcc0-0xfcff mem 0xfed00000-0xfedfffff,0xfecff000-0xfecfffff irq 9 at device 6.0 on pci0 > > fxp0: Ethernet address 08:00:46:04:31:b3 > > isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0 > > isa0: <ISA bus> on isab0 > > atapci0: <Intel PIIX4 ATA33 controller> port 0xfcb0-0xfcbf at device 7.1 on pci0 > > ata0: at 0x1f0 irq 14 on atapci0 > > ata1: at 0x170 irq 15 on atapci0 > > uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xfc60-0xfc7f irq 9 at device 7.2 on pci0 > > usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 > > usb0: USB revision 1.0 > > uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > > uhub0: 2 ports with 2 removable, self powered > > uhub0: port 1 power on failed, IOERROR > > uhub0: port 2 power on failed, IOERROR > > intpm0: <Intel 82371AB Power management controller> port 0x2180-0x218f irq 9 at device 7.3 on pci0 > > intpm0: I/O mapped 2180 > > intpm0: intr IRQ 9 enabled revision 0 > > smbus0: <System Management Bus> on intsmb0 > > smb0: <SMBus general purpose I/O> on smbus0 > > intpm0: PM I/O mapped 8000 > > pci0: <NeoMagic MagicMedia 256AV SVGA controller> at 8.0 irq 9 > > pcm0: <NeoMagic 256AV> mem 0xfea00000-0xfeafffff,0xfe000000-0xfe3fffff irq 9 at device 8.1 on pci0 > > chip1: <Sony CXD1947A FireWire Host Controller> at device 9.0 on pci0 > > pcic-pci0: <Ricoh RL5C475 PCI-CardBus Bridge> at device 10.0 on pci0 > > pci0: <unknown card> (vendor=0x127a, dev=0x2005) at 11.0 > > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > > atkbd0: <AT Keyboard> irq 1 on atkbdc0 > > psm0: <PS/2 Mouse> irq 12 on atkbdc0 > > psm0: model GlidePoint, device ID 0 > > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 > > sc0: <System console> on isa0 > > sc0: VGA <16 virtual consoles, flags=0x200> > > sio0 at port 0x3f8-0x3ff irq 4 on isa0 > > sio0: type 16550A > > sio1: configured irq 9 not in bitmap of probed irqs 0 > > pca0 at port 0x40 on isa0 > > pcic0: <Intel i82365> at port 0x3e0 iomem 0xd0000 irq 10 on isa0 > > pcic0: management irq 10 > > pccard0: <PC Card bus -- kludge version> on pcic0 > > ppc0: This ppc chipset does not support the extended I/O port range...no problem > > ppc0: <Parallel port> at port 0x378-0x37b irq 7 on isa0 > > ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode > > ppc0: FIFO with 16/16/8 bytes threshold > > ppi0: <Parallel I/O> on ppbus0 > > lpt0: <Printer> on ppbus0 > > lpt0: Interrupt-driven port > > plip0: <PLIP network interface> on ppbus0 > > unknown: <PNP0c02> can't assign resources > > unknown0: <PNP0c01> at iomem 0-0x9ffff,0xe4000-0xfffff,0x100000-0x3ffffff on isa0 > > unknown1: <PNP0c02> at iomem 0xdc000-0xdffff on isa0 > > unknown2: <PNP0200> at port 0-0xf,0x81-0x8f,0xc0-0xdf drq 4 on isa0 > > unknown: <PNP0000> can't assign resources > > unknown3: <PNP0100> at port 0x40-0x43 irq 0 on isa0 > > unknown4: <PNP0b00> at port 0x70-0x71 irq 8 on isa0 > > unknown: <PNP0303> can't assign resources > > npxisa0: <Legacy ISA coprocessor support> at port 0xf0-0xff irq 13 on isa0 > > pca1: <AT-style speaker sound> at port 0x61 on isa0 > > unknown5: <PNP0a03> at port 0xcf8-0xcff on isa0 > > unknown6: <PNP0e03> at port 0x3e1-0x3e2 on isa0 > > unknown: <PNP0401> can't assign resources > > unknown: <PNP0501> can't assign resources > > unknown: <SMCf010> can't assign resources > > unknown: <PNP0f13> can't assign resources > > IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging limited to 100 packets/entry by default > > pccard: card inserted, slot 0 > > ata1-slave: ata_command: timeout waiting for intr > > ata1-slave: identify failed > > ad0: 6194MB <IBM-DBCA-206480> [13424/15/63] at ata0-master using UDMA33 > > ad1: 3MB <MEMORYSTICK 4M 8K> [247/2/16] at ata1-master using PIO1 > > Mounting root from ufs:/dev/ad0s2a > > pid 198 (ldconfig), uid 0: exited on signal 11 (core dumped) > > sio2 at port 0x2e8-0x2ef irq 11 slot 0 on pccard0 > > sio2: type 16550A > > > > -- > > TSB Russian Express, Moscow > > Vladimir B. Grebenschikov, vova@express.ru > > > > > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > > with "unsubscribe freebsd-mobile" in the body of the message > > > > -- > n_hibma@webweaving.org > n_hibma@freebsd.org USB project > http://www.etla.net/~n_hibma/ > > -- TSB Russian Express, Moscow Vladimir B. Grebenschikov, vova@express.ru To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.21.0006131049470.47610-100000>