Date: Thu, 10 May 2007 15:41:18 +0200 From: Richard Walter <Richard.Walter@hob.de> To: Marcel Moolenaar <xcllnt@mac.com> Cc: freebsd-ia64@freebsd.org Subject: Re: Install problem HP integrity rx2660(Montecito) Message-ID: <464320FE.7050203@hob.de> In-Reply-To: <93AE228A-5E2A-4485-855C-DD2F09E09E89@mac.com> References: <461357FF.1060505@hob.de> <FFBC286D-78B2-4368-903B-2D8DA755FA4E@mac.com> <461492A3.9@hob.de> <46152B18.2000504@hp.com> <92E5D9E5-4F6A-426D-93F7-2B14AF39CD38@mac.com> <46153842.7050306@hp.com> <713E07DF-2785-4738-83A5-FBBC503E49FB@mac.com> <463B0AB3.4010102@hob.de> <93AE228A-5E2A-4485-855C-DD2F09E09E89@mac.com>
next in thread | previous in thread | raw e-mail | index | archive | help
Hello, i've waited about half an hour, nothing happened. I then tried to boot with the uniprocessor kernel and verbose mode with "set kern.smp.disabled=1" and "boot -v" Threading is not activated within the EFI cpuinfo. Regards, Richard Here is the output: Hit [Enter] to boot immediately, or any other key for command prompt. Booting [/boot/kernel/kernel] in 8 seconds... Type '?' for a list of commands, 'help' for more detailed help. OK set kern.smp.disabled=1 OK boot -v Entering /boot/kernel/kernel at 0xe000000004068000... PAL Proc at 0xe00000003f800010 SAL Proc at 0xe00000003ff9eae0, GP at 0xe00000003fe00000 SAL: AP wake-up vector: 0xff Platform clock frequency 266117891 Hz Processor ratio 1600/267, Bus ratio 1/1, ITC ratio 6/4 Skipping memory chunk start 0x100000000 Skipping memory chunk start 0x10040000000 Skipping memory chunk start 0x100ff000000 Skipping memory chunk start 0x100ff801000 Skipping memory chunk start 0x100ffa00000 Skipping memory chunk start 0x100ffe00000 Skipping memory chunk start 0x100ffe80000 ptc.e base=0x0, count1=1, count2=1, stride1=0x0, stride2=0x0 Processor supports 24 Region ID bits Trying VHPT size 0x400000 Putting VHPT at 0x400000 Splitting [0x102000-0x4000000] GDB: debug ports: uart GDB: current port: uart KDB: debugger backends: ddb gdb KDB: current backend: ddb Copyright (c) 1992-2007 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 7.0-CURRENT-200704 #0: Sat Apr 14 03:19:00 UTC 2007 root@pluto1.freebsd.org:/usr/obj/usr/src/sys/GENERIC Using 32 colors for the VM-PQ tuning (0, 0) UNWIND: table added: base=e000000004000000, start=e0000000049c73e8, end=e0000000049ff728 Preloaded elf kernel "/boot/kernel/kernel" at 0xe0000000053cc940. Preloaded mfs_root "/boot/mfsroot" at 0xe0000000053cca20. CPU: Montecito (1594.71-Mhz Itanium 2) Origin = "GenuineIntel" Revision = 7 Features = 0x5<LB,AO> real memory = 1050492928 (1001 MB) Physical memory chunk(s): 0x01c00000 - 0x03ffffff, 37748736 bytes (4608 pages) 0x053ce000 - 0x3d971fff, 945438720 bytes (115410 pages) 0x3fc00000 - 0x3fdd5fff, 1925120 bytes (235 pages) avail memory = 978149376 (932 MB) FPSWA Revision = 0x10012, Entry = 0xe0000100ffd18050 Table 'FACP' at 0xe00000003fdf6af8 Table 'SPCR' at 0xe00000003fdf6c30 Table 'DBGP' at 0xe00000003fdf6c80 Table 'APIC' at 0xe00000003fdf70a0 Local APIC address=0xfee00000 Local APIC override entry Local APIC address=0xfee00000 Local SAPIC entry ProcessorId=0x0, Id=0x0, Eid=0x0 Local SAPIC entry ProcessorId=0x1, Id=0x1, Eid=0x0 (disabled) Local SAPIC entry ProcessorId=0x2, Id=0x2, Eid=0x0 Local SAPIC entry ProcessorId=0x3, Id=0x3, Eid=0x0 (disabled) Local SAPIC entry ProcessorId=0x4, Id=0x4, Eid=0x0 Local SAPIC entry ProcessorId=0x5, Id=0x5, Eid=0x0 (disabled) Local SAPIC entry ProcessorId=0x6, Id=0x6, Eid=0x0 Local SAPIC entry ProcessorId=0x7, Id=0x7, Eid=0x0 (disabled) I/O SAPIC entry Id=0x0, InterruptBase=0x10, Address=0xfed20800 I/O SAPIC entry Id=0x2, InterruptBase=0x1b, Address=0xfed24800 I/O SAPIC entry Id=0x3, InterruptBase=0x26, Address=0xfed26800 I/O SAPIC entry Id=0x6, InterruptBase=0x31, Address=0xfed2c800 I/O SAPIC entry Id=0x7, InterruptBase=0x3c, Address=0xfed2e800 Table 'SPMI' at 0xe00000003fdf6cb8 Table 'CPEP' at 0xe00000003fdf6f70 Table 'SSDT' at 0xe00000003fdf3fc8 Table 'SSDT' at 0xe00000003fdf4488 Table 'SSDT' at 0xe00000003fdf48e8 Table 'SSDT' at 0xe00000003fdf5158 Table 'SSDT' at 0xe00000003fdf59c8 Table 'SSDT' at 0xe00000003fdf6238 Table 'SSDT' at 0xe00000003fdf6378 Table 'SSDT' at 0xe00000003fdf6468 Table 'SSDT' at 0xe00000003fdf65a8 Table 'SSDT' at 0xe00000003fdf6698 Table 'SSDT' at 0xe00000003fdf67d8 Table 'SSDT' at 0xe00000003fdf68c8 Table 'SSDT' at 0xe00000003fdf6a08 Table 'WDAT' at 0xe00000003fdf6da8 MCA: allocated 65536 bytes for state info. mem: <memory> null: <null device, zero device> nfslock: pseudo-device random: <entropy source, Software, Yarrow> ACPI: RSDP @ 0x0x3fde6000/0x0028 (v 2 HP) ACPI: XSDT @ 0x0x3fde602c/0x00C4 (v 1 HP rx2660 0x00000000 HP 0x00000000) ACPI: FACP @ 0x0x3fdf6af8/0x00F4 (v 3 HP rx2660 0x00000000 HP 0x00000000) ACPI: DSDT @ 0x0x3fde61c8/0xDDF1 (v 1 HP rx2660 0x00000007 INTL 0x20050309) ACPI: FACS @ 0x0x3fdf6bf0/0x0040 ACPI: SPCR @ 0x0x3fdf6c30/0x0050 (v 1 HP 0x00000000 HP 0x00000000) ACPI: DBGP @ 0x0x3fdf6c80/0x0034 (v 1 HP rx2660 0x00000000 HP 0x00000000) ACPI: APIC @ 0x0x3fdf70a0/0x00E8 (v 1 HP rx2660 0x00000000 HP 0x00000000) ACPI: SPMI @ 0x0x3fdf6cb8/0x0050 (v 4 HP rx2660 0x00000000 HP 0x00000000) ACPI: CPEP @ 0x0x3fdf6f70/0x0034 (v 1 HP rx2660 0x00000000 HP 0x00000000) ACPI: SSDT @ 0x0x3fdf3fc8/0x04B3 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf4488/0x0457 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf48e8/0x0866 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf5158/0x0866 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf59c8/0x0866 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf6238/0x0138 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf6378/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf6468/0x013C (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf65a8/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf6698/0x013C (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf67d8/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf68c8/0x013C (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: SSDT @ 0x0x3fdf6a08/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309) ACPI: WDAT @ 0x0x3fdf6da8/0x01C4 (v 1 HP rx2660 0x00000000 HP 0x00000000) acpi0: <HP> on motherboard > > o Montecito is a dual-core processor. I think it also has > hyperthreads. This may be the discrepancy between the > detection of 4 cpus and only having woken 2 (cpu 0 and 2). > Unfortunately, I don't have a montecito-based machine, > so there's no support for montecito. Try building an UP > kernel and see if it boots. > o Normally it takes a while after "acpi0: <HP> on motherboard" > before there's more output. I don't know how long you waited > but make sure it's at least 10 minutes to begin with (just > to be sure). > o Try booting verbose. It may tell a bit more. > > HTH, > ____________ Virus checked by G DATA AntiVirusKit Version: AVK 17.4565 from 10.05.2007 Virus news: www.antiviruslab.com
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?464320FE.7050203>