Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 31 May 1999 21:22:04 -0700 (PDT)
From:      Doug White <dwhite@resnet.uoregon.edu>
To:        Josef Belkovics <belkovics@albert.osu.cz>
Cc:        Josef Belkovics <belkovic@osu.cz>, freebsd-questions@FreeBSD.ORG
Subject:   Re: 3c509,ep,fbsd3.1
Message-ID:  <Pine.BSF.4.03.9905312117390.4498-100000@resnet.uoregon.edu>
In-Reply-To: <Pine.BSF.4.05.9905290208040.3641-100000@albert.osu.cz>

next in thread | previous in thread | raw e-mail | index | archive | help
On Sat, 29 May 1999, Josef Belkovics wrote:

> > > I am using fbsd 3.1 as ip+ipx router with 2x3c905 (xl,pci) + 4x3c509
> > > (ep,isa) boards.
> > 
> > Yuck.  They do make quad-port PCI Ethernet cards.  I don't know if a 66MHz
> > Pentium can handle those though.
>  
> PCI cards share irq (5) without problem. (I don't understand well your
> notice - use penquin english.)

I was suggesting that you dump your existing cards and buy 4 port Znyx PCI
cards. This way, you get 8 ports on two cards with a proven driver.  

> > > Ep boards many times stays in the state OACTIVE (tx is idle) which means
> > > that router does not route.
> 
> > > Router runs 4 years. Before installation of switches it routes well.
> > > Systat -vmstat 1 reports that p5/66 has enough capacity. I have raised
> > > timer tick (HZ=1000) but error has improved only little.
> 
> I also have raised the number of mbuf on 10240.

I doubt this has anything to do with it, but I assume you've done this
since you've gotten the omnious 'out of mbufs' panic or know how to read
netstat -m.

> > > Where is bug? In ep driver or in switches? (Please do not advise to connect
> > > 3c509 boards back into hubs - it is too late.)
> 
> > Perhaps the cabling between the swtich and ep0 is faulty?  It looks like
> > the card's getting confused and is resetting itself.
>  
> Badly.

Have you checked that cable?  It's wierd that only one card is frying.

> > The ep driver isn't the world's best.
> 
> Well. I have found in mail archive that 3c509 has the 'stuck in OACTIVE'
> (kern/6694, kern/7042). There is some patch for if_ep.c?

Not unless it was attached to the PR.

Oh well, at least ISA dies with all the 386s and 486s after Y2K.

Doug White                               
Internet:  dwhite@resnet.uoregon.edu    | FreeBSD: The Power to Serve
http://gladstone.uoregon.edu/~dwhite    | www.freebsd.org



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.03.9905312117390.4498-100000>