Date: Mon, 19 Jun 2006 12:01:05 -0400 From: John Valko <jvalko@purdue.edu> To: freebsd-current@freebsd.org Subject: Re: USB problems on Sun Ultra 40 Workstation Message-ID: <4496CA41.3010207@purdue.edu> In-Reply-To: <44934200.90303@purdue.edu> References: <44934200.90303@purdue.edu>
next in thread | previous in thread | raw e-mail | index | archive | help
John Valko wrote: > Hello all, > > I recently built 7.0-CURRENT, but I seem to be having some USB > problems. My usb keyboard works fine when the machine turns on, but > as FreeBSD boots my USB goes dead. Here is what the logs say: > > usb0: OHCI version 1.0, legacy support > usb0: SMM does not respond, resetting > usb0: <OHCI (generic) USB controller> on ohci0 > usb0: USB revision 1.0 > uhub0: <nVidia OHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb0 > usb0: port 0, set config at addr 1 failed > usb0: root hub problem, error=4 > usb1: EHCI version 1.0 > usb1: companion controller, 4 ports each: usb0 > usb1: <NVIDIA nForce4 USB 2.0 controller> on ehci0 > usb1: USB revision 2.0 > uhub1: <nVidia EHCI root hub, class 9/0, rev 2.00/1.00, addr 1> on usb1 > uhub1: 10 ports with 10 removable, self powered > uhub1: device problem (IOERROR), disabling port 7 > (I can post the full log if it would help) > > The kernel configuration is GENERIC with MAC and BREAK_TO_DEBUGGER > enabled. Here is a list of hardware in the machine: > > Sun Ultra 40 Workstation > 2 AMD Opteron Processor Model 254 (Single Core) > 1-MB On-Chip L2 Cache per Core > 4-GB (4 @ 1-GB DIMMS) Registered ECC Memory > 1 250-GB 7200 RPM SATA Disk Drive > 1 NVIDIA Quadro FX 1400 Midrange 3D Graphics Card (P/N: X7265A) > 1 DVD Dual (DVD-ROM and CD-RW Combo) > 2 10/100/1000 BaseT Ethernet Ports > 8 USB Ports > 2 IEEE 1394a Ports > 2 PCI-Express x16 Slots > 2 PCI-Express x4 Slots > 2 Conventional PCI Slots (32-bit/33 MHz) > > I have tried with USB legacy support both enabled and disabled (logs > from when enabled). USB did work correctly on 6.1-RELEASE. Has > anyone else seen this or have any suggestions? > > Thanks! > > --John > > _______________________________________________ > freebsd-current@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to > "freebsd-current-unsubscribe@freebsd.org" > I rebuilt the kernel with USB_DEBUG enabled and posted the full dmesg after boot here:\ http://www.cs.purdue.edu/homes/jvalko/kernel.messages Thanks again. --John
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4496CA41.3010207>