Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 18 Dec 2009 19:55:14 +0000
From:      Anton Shterenlikht <mexas@bristol.ac.uk>
To:        Anton Shterenlikht <mexas@bristol.ac.uk>
Cc:        freebsd-sparc64@freebsd.org
Subject:   and cdrecord [WAS: burncd error on blade 1500]
Message-ID:  <20091218195514.GA64224@mech-cluster241.men.bris.ac.uk>
In-Reply-To: <20091218184220.GA54077@mech-cluster241.men.bris.ac.uk>
References:  <20091218184220.GA54077@mech-cluster241.men.bris.ac.uk>

next in thread | previous in thread | raw e-mail | index | archive | help
On Fri, Dec 18, 2009 at 06:42:20PM +0000, Anton Shterenlikht wrote:
> on 9.0 current
> 
> # burncd -t -f /dev/acd0 data ./trydata fixate
> burncd: ioctl(CDRIOCINITTRACK): Input/output error
> #
> 
> I've hw.ata.atapi_dma=0 in /boot/loader.conf

I also tried cdrecord:

# cdrecord -v -dummy dev=1,0,0 ./z.iso
cdrecord: No write mode specified.
cdrecord: Asuming -tao mode.
cdrecord: Future versions of cdrecord may have different drive dependent default
s.
cdrecord: Continuing in 5 seconds...
Cdrecord-Clone 2.01 (sparc64-unknown-freebsd9.0) Copyright (C) 1995-2004 Jörg Sc
hilling
TOC Type: 1 = CD-ROM
scsidev: '1,0,0'
scsibus: 1 target: 0 lun: 0
cdrecord: Error 0. Cannot open SCSI driver.
cdrecord: For possible targets try 'cdrecord -scanbus'.
cdrecord: For possible transport specifiers try 'cdrecord dev=help'.

# camcontrol devlist -v
scbus0 on ata0 bus 0:
<>                                 at scbus0 target -1 lun -1 ()
scbus1 on ata1 bus 0:
<TSSTcorp CDW/DVD TS-H492C SI00>   at scbus1 target 0 lun 0 ()
<>                                 at scbus1 target -1 lun -1 ()
scbus-1 on xpt0 bus 0:
<>                                 at scbus-1 target -1 lun -1 (xpt0)
#


I've got these devices in the kernet config file:

device		ata
device		atadisk		# ATA disk drives
device		atapicd		# ATAPI CDROM drives
device		atapicam
device		auxio		# auxiliary I/O device
device		cd
device		da		# Direct Access (disks)
device		md		# Memory "disks"
device		sbus
device		sc
device		scbus		# SCSI bus (required for SCSI)

What else am I missing?

many thanks

-- 
Anton Shterenlikht
Room 2.6, Queen's Building
Mech Eng Dept
Bristol University
University Walk, Bristol BS8 1TR, UK
Tel: +44 (0)117 331 5944
Fax: +44 (0)117 929 4423



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20091218195514.GA64224>