Date: Sun, 18 Aug 1996 09:37:16 +0200 (MET DST) From: J Wunsch <j@uriah.heep.sax.de> To: freebsd-current@FreeBSD.org (FreeBSD-current users) Cc: staff@kyklopen.ping.dk (Thomas Sparrevohn) Subject: Re: My Gumby 82439HX diffs Message-ID: <199608180737.JAA00278@uriah.heep.sax.de> In-Reply-To: <Pine.BSI.3.95.960818003546.491A-100000@kyklopen> from Thomas Sparrevohn at "Aug 18, 96 00:45:12 am"
next in thread | previous in thread | raw e-mail | index | archive | help
As Thomas Sparrevohn wrote: > Thanks to everybody that responded. But I must have hit my head with a > brick and the M_EN's was wrong. Please try this patch it contains the > registerdump for the 82439HX and the 82371SB. The only real difference > between the 82371SB and the 82371FB that concerns the registers dumped > is the APIC select field. chip0 <Intel 82439HX (Triton II) PCI cache memory controller> rev 1 on pci0:0 DRAM ECC/Parity: ECC, ECC Test disabled, ^^^^^^^^^^^^^^^^^^ Is this of any concern to me? Shutdown to Port 92 disabled, Dual Processor NA# disabled, Peer Concurrency enabled, SERR# Output Type: Open drain output, Global TXC enabled Cache: 512K dual-bank pipelined-burst, NA Disable: disabled, Extended Cacheability disabled, SCFMI disabled, L1 enabled Speculative Leadoff disabled, Turn-around Insertion disabled, Memory Address Drive Strength: 8mA/8mA, 64 Mbit mode disabled Hole: None, EDO Detect mode disabled, DRAM Refrest Rate 66Mhz Turbo Read Leadoff disabled, DRAM Read Burst Timing: x-3-3-3/x-4-4-4, DRAM Write Burst Timing: x-3-3-3, Fast RAS to CAS Delay: 3 clocks, DRAM leadoff Timing: Read 7, Write 6, Precharge 4, Refresh 5 chip1 <Intel 82371SB (Triton II) PCI-ISA bridge> rev 0 on pci0:7:0 DMA Reserved Page Register Aliasing disabled 8-Bit I/O Recovery: disabled I/O Recovery Timing: 8-bit 3.5 clocks, 16-bit 3.5 clocks APIC Chip Select: disabled Extended BIOS: disabled Lower BIOS: enabled Coprocessor IRQ13: enabled Mouse IRQ12: disabled BIOSCS# Write Protect: disabled Keyboard Controller Address Location: enabled RTC Address Location: enabled Interrupt Routing: A: IRQ11, B: IRQ10, C: IRQ12, D: disabled MB0: disabled, MB1: -- cheers, J"org joerg_wunsch@uriah.heep.sax.de -- http://www.sax.de/~joerg/ -- NIC: JW11-RIPE Never trust an operating system you don't have sources for. ;-)
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199608180737.JAA00278>