Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 9 Jun 1999 13:11:41 -0700
From:      "Dainel \"The Bruce\" Keller" <dkeller@psln.com>
To:        <BrotherMaynard@psu.edu>
Cc:        <freebsd-questions@FreeBSD.ORG>
Subject:   Re: Ethernet settings ( SMC 8216C )
Message-ID:  <001601beb2b4$4ab536c0$7d3d9bce@g6200>
References:  <Pine.BSF.4.03.9906091217380.3005-100000@resnet.uoregon.edu>

next in thread | previous in thread | raw e-mail | index | archive | help
I was having this same problem just yesterday. I had to set the PnP setting
for the card with the DOS configuration utility they give you (EZStart.exe I
think it is). Then I had to change the PnP bios settings because it was
assigning my Soundcard (anybody able to get a sound blaster live up under
FreeBSD, perhaps in SB16 emulation mode?) the same IRQ the NIC was using.
Good luck,
Daniel Keller
----- Original Message -----
From: Doug White <dwhite@resnet.uoregon.edu>
To: Joe Lerch III <BrotherMaynard@psu.edu>
Cc: <freebsd-questions@FreeBSD.ORG>
Sent: Wednesday, June 09, 1999 12:18 PM
Subject: Re: Ethernet settings ( SMC 8216C )


> On Sat, 5 Jun 1999, Joe Lerch III wrote:
>
> > Hello.
> >
> > I recently installed FreeBSD 3.1, however I am having problems with the
network configuration.  I am on a
> > small TCP/IP network consisting of three computers.  One computer acts
as a gateway for the other two

> > uses dial on demand ).  Whenever I try to telnet to any of the other
computers on the network I receive the
> > message:    /kernal: ed0: device timeout
>
> The resources of the Ethernet card does not match the resources the
> kernel's ed0 device is programmed with, or you have a cable problem.
>
> Doug White
> Internet:  dwhite@resnet.uoregon.edu    | FreeBSD: The Power to Serve
> http://gladstone.uoregon.edu/~dwhite    | www.freebsd.org
>
>
>
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-questions" in the body of the message
>



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?001601beb2b4$4ab536c0$7d3d9bce>