Date: Mon, 13 Mar 2000 22:20:23 +0100 From: Jesper Skriver <jesper@skriver.dk> To: Anne Marcel Roorda <marcel@eu.uu.net> Cc: Morten Seeberg <ml@seeberg.dk>, mobile@freebsd.org Subject: Re: pcm driver on Thinkpad 600E (2645) Message-ID: <20000313222023.A52969@skriver.dk> In-Reply-To: <QQigjs11040.200003132109@anocserve1.ams.ops.eu.uu.net>; from marcel@eu.uu.net on Mon, Mar 13, 2000 at 10:09:11PM %2B0100 References: <20000313214255.B52797@skriver.dk> <QQigjs11040.200003132109@anocserve1.ams.ops.eu.uu.net>
next in thread | previous in thread | raw e-mail | index | archive | help
--ZPt4rx8FFjLCG7dd
Content-Type: text/plain; charset=us-ascii
On Mon, Mar 13, 2000 at 10:09:11PM +0100, Anne Marcel Roorda wrote:
>> >
>> > Adding "options PNPBIOS" to the kernel config should get this
>> > working.
>> >
>> > From a working TP600E:
>> >
>> > csa0: <Crystal Semiconductor CS4610/4611 Audio accelerator> mem 0x50000000-
>> 0x500fffff,0x50100000-0x50100fff irq 11 at device 6.0 on pci0
>> > pcm0: <CS423x-PCI> at port 0x530-0x537,0x388-0x38b,0x220-0x233 irq 5 drq 1,
>> 0 on isa0
>>
>> This got my sound working, but now ep0 (a 3c589c) doesn't work, it
>> complains like
>>
>> ep0: No irq?!
>>
>> It works find when I remove PNPBIOS again, any ideas ?
>
> Hi,
>
> Yes, a few :)
>
> I'm assuming that you're using the PCMCIA version. If you
> check the list of available IRQ's, then you'll probably find one
> that's in use already listed there.
>
> I'm including the pccard.conf file as I'm currently using it,
> stripped so it only contains things that I actually use, and all
> cards configured to allow me to mix and match as I need them.
I've tried only to include irq 10 (that is normally used) in the list,
and listing it at the config line (config 0x1 "ep0" 10), none of these
does the trick, and irq 10 is not used, dmesg attached ....
/Jesper
--
Jesper Skriver, jesper(at)skriver(dot)dk - CCIE #5456
Work: Network manager @ AS3292 (Tele Danmark DataNetworks)
Private: Geek @ AS2109 (A much smaller network ;-)
One Unix to rule them all, One Resolver to find them,
One IP to bring them all and in the zone to bind them.
--ZPt4rx8FFjLCG7dd
Content-Type: text/plain
Content-Description: dmesg.pnp.txt
Content-Disposition: attachment; filename="dmesg.pnp.txt"
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 4.0-CURRENT #4: Mon Mar 13 21:22:22 CET 2000
root@tam:/usr/src/sys/compile/TAM
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (363.96-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x66a Stepping = 10
Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR>
real memory = 66912256 (65344K bytes)
config> q
avail memory = 61743104 (60296K bytes)
Preloaded elf kernel "kernel" at 0xc0303000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc030309c.
Pentium Pro MTRR support enabled
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <NeoMagic MagicMedia 256AV SVGA controller> at 0.0 irq 11
pcic-pci0: <TI PCI-1251 PCI-CardBus Bridge> mem 0x50102000-0x50102fff irq 11 at device 2.0 on pci0
pcic-pci1: <TI PCI-1251 PCI-CardBus Bridge> mem 0x50101000-0x50101fff irq 11 at device 2.1 on pci0
csa0: <Crystal Semiconductor CS4610/4611 Audio accelerator> mem 0x50000000-0x500fffff,0x50100000-0x50100fff irq 11 at device 6.0 on pci0
pcm0: <CS461x PCM Audio> on csa0
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x8400-0x841f irq 11 at device 7.2 on pci0
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
chip1: <Intel 82371AB Power management controller> port 0xefa0-0xefaf at device 7.3 on pci0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
pcic: polling mode
pcic: polling mode
pcic0: <Intel i82365> on isa0
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250
unknown: <PNP0000> can't assign resources
unknown0: <PNP0200> at port 0-0xf,0x80-0x8f,0xc0-0xdf drq 4 on isa0
unknown1: <PNP0100> at port 0x40-0x43 irq 0 on isa0
unknown2: <PNP0b00> at port 0x70-0x73 irq 8 on isa0
unknown: <PNP0800> can't assign resources
unknown: <PNP0303> can't assign resources
unknown: <IBM3780> can't assign resources
unknown3: <PNP0c04> at port 0xf0-0xff irq 13 on isa0
unknown: <PNP0700> can't assign resources
unknown4: <PNP0a03> at port 0xcf8-0xcff on isa0
unknown5: <PNP0c02> at port 0x22,0x2e-0x2f,0x92,0xb2-0xb3,0x4d0-0x4d1,0x15e0-0x15ef,0xef00-0xefaf iomem 0-0x9ffff,0xf0000-0xfffff,0x100000-0x3ffffff,0xffff0000-0xffffffff on isa0
unknown6: <PNP0400> at port 0x3bc-0x3bf irq 7 on isa0
unknown: <PNP0501> can't assign resources
pcm1: <CS423x-PCI> at port 0x530-0x537,0x388-0x38b,0x220-0x233 irq 5 drq 1,0 on isa0
unknown7: <CSC0110> at port 0x538-0x53f on isa0
unknown8: <CSC0101> at port 0x200-0x207 on isa0
unknown: <CSC0103> can't assign resources
unknown9: <IBM3765> at port 0x130-0x13f,0x2f8-0x2ff irq 3,10 drq 7 on isa0
unknown: <IBM0071> can't assign resources
unknown10: <PNP0e03> at port 0x3e0-0x3e1 on isa0
unknown: <PNP0680> can't assign resources
unknown: <PNP0680> can't assign resources
unknown11: <PNP0c02> on isa0
IP packet filtering initialized, divert enabled, rule-based forwarding disabled, default to deny, logging limited to 100 packets/entry by default
DUMMYNET initialized (000106)
ad0: 6149MB <HITACHI_DK239A-65B> [13328/15/63] at ata0-master using UDMA33
acd0: CDROM <TOSHIBA CD-ROM XM-1902B> at ata1-master using PIO4
Mounting root from ufs:/dev/ad0s2a
pccard: card inserted, slot 1
cmd ntpd pid 95 tried to use non-present sched_get_priority_max
cmd ntpd pid 95 tried to use non-present sched_setscheduler
ep0: No irq?!
--ZPt4rx8FFjLCG7dd--
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20000313222023.A52969>