Date: Wed, 21 Oct 1998 14:18:21 -0400 (EDT) From: "Joe \"Marcus\" Clarke" <marcus@jaguar.ir.miami.edu> To: FreeBSD User Questions List <freebsd-questions@FreeBSD.ORG> Subject: Shared IRQ 9 Message-ID: <Pine.OSF.4.05.9810211411180.738-100000@jaguar.ir.miami.edu>
next in thread | raw e-mail | index | archive | help
I am trying to install FreeBSD 3.0 RELEASE on a new HP Kayak with an HP NE2100 ethernet card in it. The ethernet card is detected as an lnc1 at irq 9. So, however, is the Matrox video card. Everytime I go to initialize the ethernet card using ifconfig, I get a kernel messages telling me initialization failed. Both of these cards are PCI (the Matrox is actually AGP). I can't figure out in the BIOS how to change IRQs for either the ethernet card or the video card. In my kernel config, I only have the ISA config for lnc1. Should I remove this and put simply a device lnc1 ?? The boot probe seems to detect it just fine. It just cannot bind any protocols to it. I didn't notice any flags I could set on it using ifconfig. It is a 10/100 card. All mailing list searchs proved to be similar, but not exact. I think Greg or Doug mentioned the above lnc1 option. Again, this is an HP Kayak 350 with an HP 10/100 lnc1-type PCI ethernet card and a Matrox AGP video card. I appreciate any suggestions you may have. Thanks. Joe Clarke To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.OSF.4.05.9810211411180.738-100000>