Date: Wed, 23 Jun 2004 09:16:01 +0200 From: Stefan =?iso-8859-1?Q?E=DFer?= <se@FreeBSD.org> To: Lukas Ertl <le@FreeBSD.org> Cc: current@FreeBSD.org Subject: Re: Testers wanted: USB printers Message-ID: <20040623071601.GA1869@StefanEsser.FreeBSD.org> In-Reply-To: <20040622220540.V640@korben.in.tern> References: <20040622220540.V640@korben.in.tern>
next in thread | previous in thread | raw e-mail | index | archive | help
On 2004-06-22 22:06 +0200, Lukas Ertl <le@FreeBSD.org> wrote: > Hi, > > I'd like to merge a ulpt(4) patch from NetBSD, but since I don't have a > USB printer I'd be glad if someone out there owning such a piece of > hardware could test it: > > <http://people.freebsd.org/~le/ulpt.diff>; The patch doesin't break anything on my system with a PCL compatible laser printer connected via USB: ulpt0: SAMSUNG ELECTRONICS CO., LT Samsung ML-6060 Series, rev 1.10/1.00, addr 2, iclass 7/1 ulpt0: using bi-directional mode The following message lines correspond to switching the printer off and on again (with patch; no change at all to the driver without the patch): ulpt0: at uhub1 port 2 (addr 2) disconnected ulpt0: detached ulpt0: SAMSUNG ELECTRONICS CO., LT Samsung ML-6060 Series, rev 1.10/1.00, addr 2, iclass 7/1 ulpt0: using bi-directional mode Printing works fine (tested from OpenOffice via CUPS/ghostscript/PCL backend). System is an Athlon XP with VIA KT400 chip set: uhci0: <VIA 83C572 USB controller> port 0xa000-0xa01f irq 21 at device 16.0 on pci0 uhci0: [GIANT-LOCKED] usb0: <VIA 83C572 USB controller> on uhci0 usb0: USB revision 1.0 uhci1: <VIA 83C572 USB controller> port 0x9800-0x981f irq 21 at device 16.1 on pci0 uhci1: [GIANT-LOCKED] usb1: <VIA 83C572 USB controller> on uhci1 usb1: USB revision 1.0 uhci2: <VIA 83C572 USB controller> port 0x9400-0x941f irq 21 at device 16.2 on pci0 uhci2: [GIANT-LOCKED] usb2: <VIA 83C572 USB controller> on uhci2 usb2: USB revision 1.0 ehci_pci_attach: companion usb0 ehci_pci_attach: companion usb1 ehci_pci_attach: companion usb2 usb3: EHCI version 1.0 usb3: companion controllers, 2 ports each: usb0 usb1 usb2 usb3: <EHCI (generic) USB 2.0 controller> on ehci0 usb3: USB revision 2.0 Regards, STefan
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20040623071601.GA1869>