Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 27 Dec 2005 08:39:34 +0100
From:      Chris Gilbert <Chris@lainos.org>
To:        freebsd-current@freebsd.org
Cc:        Eric Anholt <eta@lclark.edu>, Joshua Tinnin <krinklyfig@comcast.net>
Subject:   Re: ATI on FreeBSD! FireGL Linux Driver Port
Message-ID:  <200512270839.35248.Chris@lainos.org>
In-Reply-To: <200512270033.25933.krinklyfig@comcast.net>
References:  <000001c60aa3$06943100$642a15ac@smiley> <1135668166.1065.45.camel@leguin> <200512270033.25933.krinklyfig@comcast.net>

next in thread | previous in thread | raw e-mail | index | archive | help
Sounds good!

Also, make sure to add a couple of xorg.conf lines in regards to this as=20
explained in the README.

By default, it will try to involve Xv with its GL bits and fail, therefore =
not=20
exposing proper Xv acceleration. (xvinfo will report no available adapters)

By adding the following two lines, the correct "GL-less" accelerated behavi=
or=20
will be restored: (These go in the "Device" section)

        Option "VideoOverlay"   "on"
        Option "OpenGLOverlay"  "off"

On Tuesday 27 December 2005 08:33, Joshua Tinnin wrote:
> On Tue 27 Dec 05 00:22, Eric Anholt <eta@lclark.edu> wrote:
> > On Tue, 2005-12-27 at 00:10 -0700, Joshua Tinnin wrote:
> > > On Mon 26 Dec 05 22:30, Chris Gilbert <Chris@lainos.org> wrote:
> > > > Sure!
> > > >
> > > > Below is a support list based on what ATI reports the driver
> > > > supports.
> > > >
> > > > Everything here should work as advertised, but to be sure, if you
> > > > have success with a particular card then let me know and I'll
> > > > mark the support as confirmed.
> > > >
> > > > It supports: (Put into a sane order, as opposed to what is on the
> > > > ATI site)
> > >
> > > <snip>
> > >
> > > > Radeon=AE 9600 series
> > >
> > > I have an ATI Radeon 9600XT, and I'm proud to report it's been
> > > working for the last hour with no problems. I can live without the
> > > 3D acceleration in FreeBSD, but 2D acceleration helps
> > > significantly. Finally using my card's memory instead of the
> > > system's.
> >
> > Hmm.  X.Org should be supporting the same 2d acceleration for 9600s
> > as fglrx.  Was that not the case?
>
> Well, rather, it seems to be working much better now. The radeon X.Org
> driver never did seem to do 2D accel very well, at least in my
> experience, though the logs tell me it was working. It seems like it's
> actually working now, though I guess what I said previously wasn't
> precise.
>
> - jt
> _______________________________________________
> freebsd-current@freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200512270839.35248.Chris>