Date: Thu, 14 Oct 2004 14:06:19 +0530 From: Subhro <subhro.kar@gmail.com> To: "freebsd@dreamchaser.org" <freebsd@dreamchaser.org> Cc: FreeBSD Questions <freebsd-questions@freebsd.org> Subject: Re: Disk geometry, 5.3b7 install Message-ID: <b2807d040410140136d6029d8@mail.gmail.com> In-Reply-To: <416E32C9.2030905@dreamchaser.org> References: <416E2142.8090909@dreamchaser.org> <b2807d0404101400155a1d91dc@mail.gmail.com> <416E32C9.2030905@dreamchaser.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, 14 Oct 2004 02:03:21 -0600, freebsd@dreamchaser.org > The only problem is that the geometry was reported as bad by > sysinstall, and implied I needed to change it. > Yet the partition step appears to have changed it already, or is > assuming it will be changed. > I don't understand what the situation is: > sysinstall reported geometry as 155061/16/63 and said it was bad > then partitioning assumes it will be 9729/255/63 Ignore the warning and proceed with the install. The partitioning utility had already guessed the correct values and will proceed it. BTW may I have the part number of the drive? I would like to check the hardware literature. > Do I actually have to run pfdisk to change it from 155061/16/63 to > 9729/255/63? No you dont need to do it. > > One more question: > > The installation notes say the root partition must be below cylinder > 1024. <snip> This one was valid for old BIOSses which blindly believed the fact that all kinds of bootable partitions MUST start under cylinder 1024. This does not hold true if the onboard BIOS is not older than 3 years. > Thanks, You are most welcome Regards S. -- Subhro Sankha Kar School of Information Technology Block AQ-13/1 Sector V ZIP 700091 India
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?b2807d040410140136d6029d8>