Date: Thu, 11 May 1995 15:25:41 -0700 (PDT) From: "Rodney W. Grimes" <rgrimes@gndrsh.aac.dev.com> To: l3pqc@qcunix.acc.qc.edu (YING KEVIN) Cc: bugs@FreeBSD.org Subject: Re: 1st install boot hangs Message-ID: <199505112225.PAA13385@gndrsh.aac.dev.com> In-Reply-To: <Pine.ULT.3.90.950511155734.11721A-100000@qcunix.acc.qc.edu> from "YING KEVIN" at May 11, 95 04:23:28 pm
next in thread | previous in thread | raw e-mail | index | archive | help
> > Dear FreeBSD experts! > > I newly bought a pentium 90 with 1GB SCSI HD for freeBSD. I tried to > install FreeBSD 2.0 with Walnut CD distribution. Installation boot > hangs before the initial welcome screen shows. Could you help me out > here?! This looks like an Intel Triton chip set, is this the ASUS PCI/I-P54TP4 motherboard? Or is it the SuperMicro or Intel Zappa board? Also have you done anthing in the BIOS setup values like set the floppy swap drives?? Try setting the BIOS vales to ``setup defaults''. > Kevin > > > error message is as following: > > boot FreeBSD from boot disk: > ... > pci0: scanning device 0..31, mechanism=1 > pci0:0: INTEL CORPORATION, device=0x122d, class=bridge [not supported] > pci0:7: INTEL CORPORATION, device=0x122e, class=bridge [not supported] > graphics0 <display device> on pci0:18 > changing root device to fd0c > ...........(/*it hangs right here*/) > > /*After Ctrl+Alt+Del was hit*/ > Fatal trap 12: page fault while in kernel mode This happens if the system has not started the init process yet :-(, the kernel attempts to deliver a signal to pid 1, which does not exist at this time :-(. -- Rod Grimes rgrimes@gndrsh.aac.dev.com Accurate Automation Company Custom computers for FreeBSD
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199505112225.PAA13385>