Date: Thu, 26 Apr 2007 17:52:55 -0000 (GMT) From: jhall@vandaliamo.net To: "Derek Ragona" <derek@computinginnovations.com> Cc: jhall@vandaliamo.net, freebsd-questions@freebsd.org Subject: Re: FreeBSD 6.2 Boot Issue Message-ID: <2534.65.117.48.155.1177609975.squirrel@admintool.trueband.net> In-Reply-To: <6.0.0.22.2.20070426112024.026c7ec0@mail.computinginnovations.com> References: <2172.65.117.48.155.1177602567.squirrel@admintool.trueband.net> <6.0.0.22.2.20070426112024.026c7ec0@mail.computinginnovations.com>
next in thread | previous in thread | raw e-mail | index | archive | help
Both of those checked OK. Is it possible I have specified the C/H/S incorrectly during setup? Thanks, Jay > At 10:49 AM 4/26/2007, jhall@vandaliamo.net wrote: >>I have installed FreeBSD 6.2 on an HP Proliant G5 server with an E200i >>Smart Controller installed. The installation was flawless. >> >>When I reboot the server after the installation, the boot loader screen >> is >>displayed. I press F1 and the system beeps and comes back to the boot >>loader prompt. >> >>What should I be looking at? I am at a loss since I usually end up with >>leftover hardware and this time I acutally got to purchase new hardware >>just for this project. >> >>Any suggestions would be greatly appreciated. >> >>Thanks for your help. > > Check your BIOS that you are ALLOWING the boot sector to be written. > > If that is OK, try disabling hyperthreading if that is turned on in your > BIOS. > > -Derek > > -- > This message has been scanned for viruses and > dangerous content by MailScanner, and is > believed to be clean. > MailScanner thanks transtec Computers for their support. > >
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?2534.65.117.48.155.1177609975.squirrel>