Skip site navigation (1)Skip section navigation (2)
Date:      Sun, 15 Jan 2012 22:50:54 +0100 (CET)
From:      Marco Beishuizen <>
To:        =?UTF-8?Q?Erik_N=C3=B8rgaard?= <>
Subject:   Re: ipv6 in FreeBSD 9
Message-ID:  <alpine.BSF.2.00.1201152245250.3144@yokozuna.lan>
In-Reply-To: <>
References:  <alpine.BSF.2.00.1201141758220.3151@yokozuna.lan> <> <alpine.BSF.2.00.1201152138080.3353@yokozuna.lan> <>

Next in thread | Previous in thread | Raw E-Mail | Index | Archive | Help
  This message is in MIME format.  The first part should be readable text,
  while the remaining parts are likely unreadable without MIME-aware tools.

Content-Type: TEXT/PLAIN; charset=UTF-8; format=flowed
Content-Transfer-Encoding: QUOTED-PRINTABLE

On Sun, 15 Jan 2012, the wise Erik N=C3=B8rgaard wrote:

>>> Don't use ipv6, but reading above: Did you replace ipv6_enable with
>>> ipv6_activate_all_interfaces? because the error seems to tell you that
>>> you must keep ipv6_enable
>> I replaced it with the new lines because according to the manpage
>> ipv6_enable is deprecated. But why shouldn't I use ipv6?
> Sorry, meant to say, I don't use ipv6 so I can't do much debugging.

Aaah, :-), perhaps I should have read better.

>>> Or, maybe there was an error with mergemaster? old scripts, new kernel
>>> variables?
>> I ran mergemaster, but didn't get any error messages. Afaik all scripts
>> in /etc are new.
> OK, in the error messages you posted it seems that some script checks or =
> these variables. Maybe try to run the different networking scripts manual=
> and see where it fails.

Thanks for the tip. I'll do some trial and error and dig deeper.

Paul's Law:
 =09You can't fall off the floor.

Want to link to this message? Use this URL: <>