Date: Thu, 18 May 2000 19:16:06 -0400 (EDT) From: wietse@porcupine.org (Wietse Venema) To: dieringe@physik.fu-berlin.de (Martin Dieringer) Cc: pir@pir.net, wietse@porcupine.org, freebsd-mobile@freebsd.org, freebsd-scsi@freebsd.org Subject: Re: Need FreeBSD 4.0 removable SCSI support Message-ID: <20000518231606.5AE974563D@spike.porcupine.org> In-Reply-To: <Pine.OSF.4.10.10005182338100.24840-100000@sirius.physik.fu-berlin.de> from Martin Dieringer at "May 18, 0 11:40:30 pm"
next in thread | previous in thread | raw e-mail | index | archive | help
Martin Dieringer:
> We exchanged 3 or 4 emails and I sent him my kernel config, rc.conf
> and dmesg output. so he should probably be able to try it out.
Summary: Generic FreeBSD 4.0-RELEASE + Thinkpad 600 + SlimSCSI
1460B + Jaz 2GB locks up the machine.
Summary: I built a machine according to Martin Dieringer's specs
and it still locks up. For details, see below.
All this works OK with FreeBSD 2.2.8. And SUSE Linux can talk to
the Jaz drive even before Linux is installed.
I conclude that FreeBSD 4.0 cannot work with my hardware. Perhaps
it gets upset by garbage from the Jaz disk. I do not care anymore.
I could try if FreeBSD 3.4+PAO is up to the task, but then I would
again be stuck one major release behind the times. That is not a
good long-term solution.
It looks like Linux will have to be my long-term solution. It was
nice knowing you people.
Wietse
- I upgraded from FreeBSD 4.0-RELEASE to FreeBSD 4.0-20000518 STABLE.
- I built Martin Dieringer's kernel configuration, with two changes:
no MAXMEM (I removed all but the last 64MB memory) and no soft
updates (undefined symbols).
- I installed Martin Dieringer's rc.conf file, unmodified.
And here are the results:
- The SlimSCSI 1460B card is recognized.
- After "camcontrol rescan 0" the machine locks up.
Below is dmesg output from my machine, and diffs against Martin
Dieringer's dmesg output.
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 4.0-20000518-STABLE #0: Thu May 18 22:13:38 EDT 2000
wietse@bristle.watson.ibm.com:/usr/src/sys/compile/THINKPAD
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (298.42-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x652 Stepping = 2
Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR>
real memory = 66912256 (65344K bytes)
avail memory = 61505536 (60064K bytes)
Preloaded elf kernel "kernel" at 0xc0387000.
ccd0-3: Concatenated disk drivers
Pentium Pro MTRR support enabled
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
pcib0: <Intel 82443BX host to PCI bridge (AGP disabled)> on motherboard
pci0: <PCI bus> on pcib0
pcic-pci0: <TI PCI-1250 PCI-CardBus Bridge> mem 0x20301000-0x20301fff at device 2.0 on pci0
pcic-pci1: <TI PCI-1250 PCI-CardBus Bridge> mem 0x20300000-0x20300fff at device 2.1 on pci0
pci0: <NeoMagic MagicGraph 128XD SVGA controller> at 3.0 irq 11
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x8400-0x841f irq 11 at device 7.2 on pci0
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
chip1: <Intel 82371AB Power management controller> port 0xefa0-0xefaf at device 7.3 on pci0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3b0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250
pcic0: <Intel i82365> at port 0x3e0-0x3e1 on isa0
pcic0: Polling mode
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
ppc0: cannot reserve I/O port range
unknown: <PNP0000> can't assign resources
unknown0: <PNP0200> at port 0-0xf,0x80-0x8f,0xc0-0xdf drq 4 on isa0
unknown1: <PNP0100> at port 0x40-0x43 irq 0 on isa0
unknown2: <PNP0b00> at port 0x70-0x73 irq 8 on isa0
unknown3: <PNP0800> at port 0x61 on isa0
unknown: <PNP0303> can't assign resources
unknown: <IBM3780> can't assign resources
unknown4: <PNP0c04> at port 0xf0-0xff irq 13 on isa0
unknown: <PNP0700> can't assign resources
unknown5: <PNP0a03> at port 0xcf8-0xcff on isa0
unknown6: <PNP0c02> at port 0x22,0x2e-0x2f,0x92,0xb2-0xb3,0x4d0-0x4d1,0x15e0-0x15ef,0xef00-0xefaf iomem 0-0x9ffff,0xf0000-0xfffff,0x100000-0x3ffffff,0xffff0000-0xffffffff on isa0
unknown: <PNP0400> can't assign resources
unknown: <PNP0501> can't assign resources
pcm0: <CS423x> at port 0x530-0x537,0x388-0x38b,0x220-0x233 irq 5 drq 1,0 on isa0
unknown7: <CSC0010> at port 0x538-0x53f on isa0
unknown8: <CSC0001> at port 0x10 on isa0
unknown: <CSC0003> can't assign resources
unknown: <IBM3760> can't assign resources
unknown: <IBM0071> can't assign resources
unknown: <PNP0e03> can't assign resources
unknown: <PNP0680> can't assign resources
unknown: <PNP0680> can't assign resources
unknown9: <PNP0c02> at iomem 0xca000-0xcbfff on isa0
IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging lim
ited to 100 packets/entry by default
IP Filter: initialized. Default = pass all, Logging = enabled
IP Filter: v3.3.8
ad0: 6149MB <IBM-DBCA-206480> [13328/15/63] at ata0-master using UDMA33
acd0: CDROM <TOSHIBA CD-ROM XM-1702BC> at ata1-master using PIO4
Mounting root from ufs:/dev/ad0s1a
4,5c4,5
< FreeBSD 4.0-STABLE #0: Sun May 14 16:37:24 CEST 2000
< root@pc.nowhere.local:/usr/src/sys/compile/THINKPAD
---
> FreeBSD 4.0-20000518-STABLE #0: Thu May 18 22:13:38 EDT 2000
> wietse@bristle.watson.ibm.com:/usr/src/sys/compile/THINKPAD
7,8c7,8
< CPU: Pentium II/Pentium II Xeon/Celeron (232.11-MHz 686-class CPU)
< Origin = "GenuineIntel" Id = 0x650 Stepping = 0
---
> CPU: Pentium II/Pentium II Xeon/Celeron (298.42-MHz 686-class CPU)
> Origin = "GenuineIntel" Id = 0x652 Stepping = 2
10,12c10,12
< real memory = 100073472 (97728K bytes)
< avail memory = 93618176 (91424K bytes)
< Preloaded elf kernel "kernel" at 0xc0390000.
---
> real memory = 66912256 (65344K bytes)
> avail memory = 61505536 (60064K bytes)
> Preloaded elf kernel "kernel" at 0xc0387000.
52,57c52
< ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
< ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
52,57c52
< ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
< ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
< ppi0: <Parallel I/O> on ppbus0
< lpt0: <Printer> on ppbus0
< lpt0: Interrupt-driven port
< plip0: <PLIP network interface> on ppbus0
---
> ppc0: cannot reserve I/O port range
68c63
< unknown6: <PNP0c02> at port 0x22,0x2e-0x2f,0x92,0xb2-0xb3,0x4d0-0x4d1,0x15e0-0x15ef,0xef00-0xefaf iomem 0-0x9ffff,0xf0000-0xfffff,0x100000-0x5ffffff,0xffff0000-0xffffffff on isa0
---
> unknown6: <PNP0c02> at port 0x22,0x2e-0x2f,0x92,0xb2-0xb3,0x4d0-0x4d1,0x15e0-0x15ef,0xef00-0xefaf iomem 0-0x9ffff,0xf0000-0xfffff,0x100000-0x3ffffff,0xffff0000-0xffffffff on isa0
84c79
< ad0: 11513MB <IBM-DARA-212000> [23392/16/63] at ata0-master using UDMA33
---
> ad0: 6149MB <IBM-DBCA-206480> [13328/15/63] at ata0-master using UDMA33
86c81
< Mounting root from ufs:/dev/ad0s2a
---
> Mounting root from ufs:/dev/ad0s1a
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20000518231606.5AE974563D>