Date: Mon, 24 Sep 2001 18:04:10 +0200 From: Olivier Saut <Olivier.Saut@gmm.insa-tlse.fr> To: freebsd-stable@freebsd.org Subject: usb0 controller halted error Message-ID: <20010924180410.B512@optimistic.dyndns.org>
next in thread | raw e-mail | index | archive | help
--PNTmBPCT7hxwcZjr Content-Type: text/plain; charset=us-ascii Content-Disposition: inline Hello, I run the Alcatel Speedtouch USB driver (/usr/ports/net/pppoa or http://www.xsproject.org/speedtouch/) for my ADSL line. Under heavy upload, the connection stops, the modem switches off. The console keeps printing "usb0 controller halted". So far the only solution I have found is to reboot the computer. The system is : FreeBSD optimistic 4.4-STABLE FreeBSD 4.4-STABLE #10: Sun Sep 23 13:13:38 CEST 2001 root@optimistic:/usr/obj/usr/src/sys/opt_db i386 but I have this problem with 4.3 as well. The error printf comes from /usr/src/sys/dev/usb/uhci.c which hasn't been touched for a year. The computer is an Athlon on a Asus A7V MB. dmesg is attached. Is this a known problem? Is there a solution for it? The BIOS setting Advanced->"System Performance" is set to "Normal" instead of the default "Optimal". "Optimal" makes this error happen more often. The BIOS version is the last one from Asus site. The out bandwith is limited to 128Kbits/s by dummynet on the tun0 interface. Thanks for your help! Olivier --PNTmBPCT7hxwcZjr Content-Type: text/plain; charset=us-ascii Content-Disposition: attachment; filename=dmesg Copyright (c) 1992-2001 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.4-STABLE #10: Sun Sep 23 13:13:38 CEST 2001 root@optimistic:/usr/obj/usr/src/sys/opt_db Timecounter "i8254" frequency 1193182 Hz CPU: AMD Athlon(tm) Processor (807.19-MHz 686-class CPU) Origin = "AuthenticAMD" Id = 0x642 Stepping = 2 Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR> AMD Features=0xc0440000<<b18>,AMIE,DSP,3DNow!> real memory = 268353536 (262064K bytes) config> q avail memory = 257650688 (251612K bytes) Preloaded elf kernel "kernel" at 0xc0389000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc038909c. Preloaded elf module "agp.ko" at 0xc03890ec. Pentium Pro MTRR support enabled md0: Malloc disk Using $PIR table, 9 entries at 0xc00f1720 npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Host to PCI bridge> on motherboard pci0: <PCI bus> on pcib0 agp0: <VIA Generic host to PCI bridge> mem 0xe4000000-0xe7ffffff at device 0.0 on pci0 pcib2: <PCI to PCI bridge (vendor=1106 device=8305)> at device 1.0 on pci0 pci1: <PCI bus> on pcib2 pci1: <NVidia model 0110 graphics accelerator> at 0.0 irq 11 isab0: <VIA 82C686 PCI-ISA bridge> at device 4.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <VIA 82C686 ATA66 controller> port 0xd800-0xd80f at device 4.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 uhci0: <VIA 83C572 USB controller> port 0xd400-0xd41f irq 5 at device 4.2 on pci0 usb0: <VIA 83C572 USB controller> on uhci0 usb0: USB revision 1.0 uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered ugen0: ALCATEL Speed Touch USB , rev 1.10/0.00, addr 2 uhci1: <VIA 83C572 USB controller> port 0xd000-0xd01f irq 5 at device 4.3 on pci0 usb1: <VIA 83C572 USB controller> on uhci1 usb1: USB revision 1.0 uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered uhub2: ALCOR Generic USB Hub, class 9/0, rev 1.10/1.00, addr 2 uhub2: 4 ports with 4 removable, self powered pcm0: <Creative CT5880-C> port 0xa400-0xa43f irq 5 at device 9.0 on pci0 bktr0: <BrookTree 878> mem 0xd7000000-0xd7000fff irq 10 at device 11.0 on pci0 iicbb0: <I2C generic bit-banging driver> on bti2c0 iicbus0: <Philips I2C bus> on iicbb0 master-only smbus0: <System Management Bus> on bti2c0 bktr0: Detected a MSP3429 at 0x80 bktr0: Pinnacle/Miro TV, Philips SECAM tuner, dbx stereo, msp3400c stereo. pci0: <unknown card> (vendor=0x109e, dev=0x0878) at 11.1 irq 10 ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0xa000-0xa01f irq 5 at device 13.0 on pci0 ed0: address 52:54:05:f9:33:d5, type NE2000 (16 bit) atapci1: <Promise ATA100 controller> port 0x8400-0x843f,0x8800-0x8803,0x9000-0x9007,0x9400-0x9403,0x9800-0x9807 mem 0xd4800000-0xd481ffff irq 10 at device 17.0 on pci0 ata2: at 0x9800 on atapci1 pcib1: <Host to PCI bridge> on motherboard pci2: <PCI bus> on pcib1 orm0: <Option ROMs> at iomem 0xcc000-0xcffff,0xd0000-0xd1fff on isa0 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: model IntelliMouse, device ID 3 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A DUMMYNET initialized (010124) IP packet filtering initialized, divert disabled, rule-based forwarding disabled, default to deny, logging limited to 100 packets/entry by default ad0: 29314MB <IBM-DTLA-307030> [59560/16/63] at ata2-master UDMA100 ad1: 39266MB <IC35L040AVER07-0> [79780/16/63] at ata2-slave UDMA100 acd0: DVD-ROM <_NEC DV-5700A> at ata0-master using PIO4 acd1: CD-RW <YAMAHA CRW2100E> at ata0-slave using PIO4 Mounting root from ufs:/dev/ad0s2a --PNTmBPCT7hxwcZjr-- To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010924180410.B512>