Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 31 Jul 1998 23:43:15 +0000
From:      "Frank Pawlak" <fpawlak@execpc.com>
To:        Doug White <dwhite@resnet.uoregon.edu>, Mike Jeays <jeays@statcan.ca>
Cc:        freebsd-questions@FreeBSD.ORG
Subject:   Re: Soundblaster 16 problem
Message-ID:  <980731234315.ZM1326@darkstar.connect.com>
In-Reply-To: Doug White <dwhite@resnet.uoregon.edu> "Re: Soundblaster 16 problem" (Jul 31,  2:14pm)
References:  <Pine.BSF.4.00.9807311414020.14321-100000@resnet.uoregon.edu>

next in thread | previous in thread | raw e-mail | index | archive | help
On Jul 31,  2:14pm, Doug White wrote:
> Subject: Re: Soundblaster 16 problem
>
> On Thu, 30 Jul 1998, Mike Jeays wrote:
>
> > I have installed a SoundBlaster 16, and, judging by the good performance
> > under another operating system :-(, it is physically OK.  Under FreeBSD
> > 2.2.6, I get the following DMESG output, with the kernel config options
> > also shown below.
> >
> > The card gives brief bursts of sound only, using splay, amp and various
> > other utilities.  Any ideas, please? I presume I have an IRQ conflict,
> > and would like advice on how to track it down and fix it.
> >
> > sb0 at 0x220 irq 7 drq 1 on isa
> > sb0: <SoundBlaster 16 4.13>
> > sbxvi0 at 0x0 drq 5 on isa
> > sbxvi0: <SoundBlaster 16 4.13>
> > sbmidi0 at 0x330 on isa
> >  <SoundBlaster MPU-401>
>
> Are you sure these settings are correct (IRQ 7, DMA 1,5)?  Check That
> Other Operating System's settings.  You may need to add `controller pnp0'
> to your kernel.
>

DMA 1& 5 sound about right, 0 & 5 is another possibility.  IRQ 7 is suspect
however.

Frank

> Doug White                              | University of Oregon
> Internet:  dwhite@resnet.uoregon.edu    | Residence Networking Assistant
> http://gladstone.uoregon.edu/~dwhite    | Computer Science Major
>
>
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-questions" in the body of the message
>-- End of excerpt from Doug White



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?980731234315.ZM1326>