Date: Thu, 10 Jan 2002 12:29:23 -0800 From: Yu-Shun Wang <yushunwa@ISI.EDU> To: freebsd-mobile@freebsd.org Subject: Problems with 2 Linksys PCMPC100 NICs Message-ID: <3C3DF9A3.326F789D@isi.edu>
next in thread | raw e-mail | index | archive | help
This is a multi-part message in MIME format.
--------------C8F5F01BD52A0B21743FA785
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
Hi,
I've been using a single Linksys PCMPC100 without any problems (FreeBSD 4.4
Release, Toshiba Libretto 110CT). But when I tried to plugin 2nd card, it
wasn't configured properly. It's recognized correctly, but ifconfig showed
missing media & status lines...
[root@abc: /etc] ifconfig
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
inet 127.0.0.1 netmask 0xff000000
ed0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 10.1.1.166 netmask 0xfffff000 broadcast 128.9.175.255
ether 00:e0:98:74:30:e6
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
ed1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 10.1.1.1 netmask 0xfffffffc broadcast 10.1.1.3
ether 00:e0:98:72:4f:d3
Here's the pccard.conf entry:
# Linksys EtherFast 10/100 PC Card (PCMPC100), model V2 and V3
card "Linksys" "/Ether[Ff]ast 10/100 PC Card \(PCMPC100.*\)/"
# config auto "ed" ? 0x80000
config auto "ed0" ? 0x80000
config auto "ed1" 10 0x80000
insert /etc/pccard_ether $device start
remove /etc/pccard_ether $device stop
But both cards are using irq3 no matter what I put in the config lines.
dmesg output was attached. Let me know if other info would help.
Thanks,
yushun.
____________________________________________________________________________
Yu-Shun Wang <yushunwa@isi.edu> Information Sciences Institute
University of Southern California
--------------C8F5F01BD52A0B21743FA785
Content-Type: text/plain; charset=us-ascii;
name="dmesg.abc"
Content-Transfer-Encoding: 7bit
Content-Disposition: inline;
filename="dmesg.abc"
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.4-RELEASE #0: Thu Dec 13 03:36:20 PST 2001
root@abc.isi.edu:/usr/src/sys/compile/KERNEL-1.26
Timecounter "i8254" frequency 1193059 Hz
CPU: Pentium/P55C (quarter-micron) (233.26-MHz 586-class CPU)
Origin = "GenuineIntel" Id = 0x581 Stepping = 1
Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory = 67174400 (65600K bytes)
avail memory = 60354560 (58940K bytes)
Preloaded elf kernel "kernel" at 0xc0469000.
Preloaded elf module "snd_maestro3.ko" at 0xc046909c.
Preloaded elf module "snd_pcm.ko" at 0xc0469140.
Intel Pentium detected, installing workaround for F00F bug
VESA: v2.0, 1984k memory, flags:0x0, mode table:0xc03c86e2 (1000022)
VESA: MagicGraph 128XD 40K SVGA BIOS
Using $PIR table, 5 entries at 0xc00f8e80
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pci0: <NeoMagic MagicGraph 128XD SVGA controller> at 4.0
chip1: <Toshiba Fast Infra Red controller> port 0xffe0-0xffff irq 11 at device 17.0 on pci0
pci_cfgintr_virgin: using routable interrupt 3
pci_cfgintr: 0:19 INTA routed to irq 3
pcic0: <Toshiba ToPIC97 PCI-CardBus Bridge> irq 3 at device 19.0 on pci0
pcic0: PCI Memory allocated: 0x44000000
pccard0: <PC Card bus (classic)> on pcic0
pci_cfgintr_search: linked (1) to configured irq 3 at 0:19:0
pci_cfgintr: 0:19 INTB routed to irq 3
pcic1: <Toshiba ToPIC97 PCI-CardBus Bridge> irq 3 at device 19.1 on pci0
pcic1: PCI Memory allocated: 0x44001000
pccard1: <PC Card bus (classic)> on pcic1
isa0: <ISA bus> on motherboard
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
ata0 at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x90 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
joy0 at port 0x201 on isa0
pca0 at port 0x40 on isa0
DUMMYNET initialized (010124)
IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging limited to 1000 packets/entry by default
IPsec: Initialized Security Association Processing.
ad0: 4126MB <TOSHIBA MK4310MAT> [8944/15/63] at ata0-master BIOSPIO
Mounting root from ufs:/dev/ad0s2a
pccard: card inserted, slot 0
pccard: card inserted, slot 1
pccard: card inserted, slot 0
ed0 at port 0x300-0x31f irq 3 slot 0 on pccard0
ed0: address 00:e0:98:74:30:e6, type Linksys (16 bit)
lxtphy0: <LXT970 10/100 media interface> on miibus0
lxtphy0: 100baseFX, 100baseFX-FDX, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
ed1 at port 0x320-0x33f irq 3 slot 1 on pccard1
ed1: address 00:e0:98:72:4f:d3, type Linksys (16 bit)
ed1: device timeout
--------------C8F5F01BD52A0B21743FA785--
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3C3DF9A3.326F789D>