Date: Wed, 14 Feb 2001 12:29:29 -0700 From: "Justin T. Gibbs" <gibbs@scsiguy.com> To: "Matthew N. Dodd" <winter@jurai.net> Cc: Joerg Wunsch <joerg_wunsch@interface-systems.de>, freebsd-scsi@FreeBSD.ORG Subject: Re: Problems with AIC7770-based controller on -current Message-ID: <200102141929.f1EJTTO54765@aslan.scsiguy.com> In-Reply-To: Your message of "Mon, 12 Feb 2001 14:29:51 EST." <Pine.BSF.4.21.0102121429230.884-100000@sasami.jurai.net>
next in thread | previous in thread | raw e-mail | index | archive | help
>> Is this current -current? Your stack traces don't seem to match up
>> with the latest code.
>
>CURRENT as of about mid-day yesterday.
I've been unable to reproduce this so far on this system. Of course,
I'm not running -current on it, that would be suicide, but the driver
should be the same between the two branches. I'll be adding another
drive to the other channel today to see if that causes a failure.
--
Justin
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.2-STABLE #1: Wed Feb 14 11:58:34 MST 2001
root@nevrast.btc.adaptec.com:/usr/src/sys/compile/NEVRAST
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium/P54C (90.20-MHz 586-class CPU)
Origin = "GenuineIntel" Id = 0x525 Stepping = 5
Features=0x3bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,APIC>
real memory = 33554432 (32768K bytes)
avail memory = 28524544 (27856K bytes)
Preloaded elf kernel "kernel" at 0xc030c000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc030c09c.
Intel Pentium detected, installing workaround for F00F bug
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
isab0: <Intel 82375EB PCI-EISA bridge> at device 2.0 on pci0
eisa0: <EISA bus> on isab0
mainboard0: <MIC0054 (System Board)> on eisa0 slot 0
ahc0: <Adaptec 274X SCSI adapter> at 0x3c00-0x3cff, irq 11 (level)
ahc0: on eisa0 slot 3
aic7770: Twin Channel, A SCSI Id=7, B SCSI Id=7, primary A, 4/255 SCBs
isa0: <ISA bus> on isab0
atapci0: <CMD 640 ATA controller !WARNING! buggy chip data loss possible>
irq 14 at device 4.0 on pci0
atapci0: Busmastering DMA not supported
atapci0: Busmastering DMA disabled
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xfce0-0xfcff mem
0xfed00000-0xfedfffff,0xfec00000-0xfec00fff irq 9 at device 13.0 on pci0
fxp0: Ethernet address 00:a0:c9:b3:bc:47
pci0: <unknown card> (vendor=0x11ab, dev=0x6320) at 14.0 irq 10
pci0: <ARK Logic 2000PV SVGA controller> at 15.0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppbus0: IEEE1284 device found
Probing for PnP devices on ppbus0:
ppi0: <Parallel I/O> on ppbus0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ep0: <3Com 3C509B-TP EtherLink III (PnP)> at port 0x210-0x21f irq 5 on isa0
ep0: Ethernet address 00:a0:24:82:d4:59
Waiting 2 seconds for SCSI devices to settle
da0 at ahc0 bus 0 target 6 lun 0
da0: <SEAGATE ST39204LW 0006> Fixed Direct Access SCSI-3 device
da0: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled
da0: 8750MB (17921835 512 byte sectors: 255H 63S/T 1115C)
Mounting root from ufs:/dev/da0s2a
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-scsi" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200102141929.f1EJTTO54765>