Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 11 Nov 2002 11:25:15 +1100
From:      Rob B <rbyrnes@ozemail.com.au>
To:        John Baldwin <jhb@FreeBSD.org>
Cc:        freebsd-alpha@freebsd.org, Andrew Gallatin <gallatin@cs.duke.edu>
Subject:   Re: 5.0 alpha install tests
Message-ID:  <5.1.0.14.2.20021111112347.05180670@pop.ozemail.com.au>
In-Reply-To: <XFMail.20021109093904.jhb@FreeBSD.org>
References:  <00f201c287d5$9f4b6f20$3164a8c0@pootah>

next in thread | previous in thread | raw e-mail | index | archive | help
At 09:39 9/11/2002 -0500, John Baldwin sent this up the stick:

>On 09-Nov-2002 Rob B wrote:
> > ----- Original Message -----
> > From: "Andrew Gallatin" <gallatin@cs.duke.edu>
> > To: "Rob B" <rbyrnes@ozemail.com.au>
> > Cc: <freebsd-alpha@FreeBSD.ORG>
> > Sent: Thursday, November 07, 2002 1:44 PM
> > Subject: Re: 5.0 alpha install tests
> >
> >
> >> Rob B writes:
> >
> >>>> sho conf
> >         Digital AlphaPC 64 274MHz
> > SRM Console V4.8-1        VMS PALcode V5.56-1, OSF PALcode V1.45-4
> > DECchip (tm) 21064A-2
> > DECchip (tm) 21071-DA Pass 1
> > DECchip (tm) 21071-CA Pass 2
> >
> > MEMORY
> > 64Meg of system memory
> >
> >
> > PCI Bus
> >     Bus 00  Slot 05: NCR 53C875 Scsi Controller
> >                                         pka0.7.0.5.0        Scsi Bus ID 7
> >                                         dka0.0.0.5.0            COMPAQ
> > BD00421936
> >     Bus 00  Slot 08:  Intel 82378IB PCI to ISA Bridge
> >
> > ISA
> > Slot        Device        Name        Type            Enabled    BaseAddr
> > IRQ        DMA
> > 0
> >                 0            MOUSE    Embedded        Yes            60
> > 12
> >                 1            KBD          Embedded        Yes            60
> > 1
> >                 2            COM1       Embedded        Yes            3f8
> > 4
> >                 3            COM2       Embedded        Yes            2f8
> > 3
> >                 4            LPT1          Embedded        Yes
> > 3bc              7
> >                 5            FLOPPY    Embedded        Yes            3f0
> > 6                2
> >
> > aylee# dmesg
> > Copyright (c) 1992-2002 The FreeBSD Project.
> > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> >         The Regents of the University of California. All rights reserved.
> > FreeBSD 5.0-DP1 #0: Sun Apr  7 07:34:25 GMT 2002
> >     murray@axpbuilder.freebsdmall.com:/usr/src/sys/alpha/compile/GENERIC
> > Preloaded elf kernel "/boot/kernel/kernel" at 0xfffffc0000814000.
> > EB64+
> > Digital AlphaPC 64 274 MHz, 274MHz
> > 8192 byte page size, 1 processor.
> > CPU: EV45 (21064A) major=6 minor=2
> > OSF PAL rev: 0x100040002012d
> > real memory  = 65019904 (63496K bytes)
> > avail memory = 55279616 (53984K bytes)
> > apecs0: <DECchip 21072 Core Logic chipset>
> > pci0: <PCI bus> on pcib0
> > sym0: <875> port 0x10000-0x100ff mem
> > 0x8205c000-0x8205cfff,0x8205d000-0x8205d0ff irq 2 at device 5.0 on pci0
> > sym0: Tekram NVRAM, ID 7, Fast-20, SE, parity checking
> > sym0: interrupting at APECS irq 2
> > pci0: <display, VGA> at device 7.0 (no driver attached)
> > isab0: <PCI-ISA bridge> at device 8.0 on pci0
> > isa0: <ISA bus> on isab0
> > dc0: <Intel 21143 10/100BaseTX> port 0x10100-0x1017f mem
> > 0x8205d100-0x8205d17f irq 3 at device 9.0 on pci0
> > dc0: interrupting at APECS irq 3
> > dc0: Ethernet address: 08:00:2b:c3:dd:56
> > miibus0: <MII bus> on dc0
> > dcphy0: <Intel 21143 NWAY media interface> on miibus0
> > dcphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> > atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
> > atkbd0: <AT Keyboard> irq 1 on atkbdc0
> > atkbd0: interrupting at ISA irq 1
> > fdc0: <enhanced floppy controller (i82077, NE72065 or clone)> at port
> > 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
> > fdc0: interrupting at ISA irq 6
> > mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
> > ppc0: <Parallel port> at port 0x3bc-0x3c3 irq 7 on isa0
> > ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
> > plip0: cannot reserve interrupt, failed.
> > lpt0: <Printer> on ppbus0
> > lpt0: Polled port
> > ppi0: <Parallel I/O> on ppbus0
> > ppc0: interrupting at ISA irq 7
> > sc0: <System console> on isa0
> > sc0: VGA <16 virtual consoles, flags=0x200>
> > sio0 at port 0x3f8-0x3ff irq 4 on isa0
> > sio0: type 16550A
> > sio0: interrupting at ISA irq 4
> > sio1: reserved for low-level i/o
> > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> > Timecounter "i8254"  frequency 1193182 Hz
> > Timecounter "alpha"  frequency 275002485 Hz
> > Waiting 15 seconds for SCSI devices to settle
> > da0 at sym0 bus 0 target 0 lun 0
> > da0: <COMPAQ BD00421936 3B00> Fixed Direct Access SCSI-2 device
> > da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing
> > Enabled
> > da0: 4091MB (8380080 512 byte sectors: 255H 63S/T 521C)
> > Mounting root from ufs:/dev/da0a
> >
> >
> > aylee# pciconf -lv
> > sym0@pci0:5:0:  class=0x010000 card=0x00000000 chip=0x000f1000 rev=0x01
> > hdr=0x00
> >     vendor   = 'Symbios Logic (NCR) (LSI Logic)'
> >     device   = '53C875, 53C876 Ultra-Wide SCSI (53C876 is dual-channel)'
> >     class    = mass storage
> >     subclass = SCSI
> > none0@pci0:7:0: class=0x030000 card=0x00000000 chip=0x0519102b rev=0x01
> > hdr=0x00
> >     vendor   = 'Matrox Graphics Inc'
> >     device   = 'MGA-2064W Millenium GUI Accelerator'
> >     class    = display
> >     subclass = VGA
> > isab0@pci0:8:0: class=0x000000 card=0x00000000 chip=0x04848086 rev=0x84
> > hdr=0x00
> >     vendor   = 'Intel Corporation'
> >     device   = '82378ZB/IB,82379AB PCI to ISA Bridge, System I/O'
> >     class    = old
> >     subclass = non-VGA display device
> > dc0@pci0:9:0:   class=0x020000 card=0x500b1011 chip=0x00191011 rev=0x30
> > hdr=0x00
> >     vendor   = 'Digital Equipment Corporation'
> >     device   = 'DC21142/3 PCI/CardBus 10/100 Mbit Ethernet Ctlr'
> >     class    = network
> >     subclass = ethernet
> >
> >
> >> Also, did this work with previous version of FreeBSD, or is this the
> >> first time this machine was installed with FreeBSD?
> >
> > It's never worked, but I've also not needed it prior to now
>
>Do you have an ISA ATA controller?  If so, try breaking into the
>loader (hit a key during the 10 second countdown) and type in the
>following:
>
>set hint.ata.0.at="isa"
>set hint.ata.0.port="0x1f0"
>set hint.ata.0.irq="14"
>set hint.ata.1.at="isa"
>set hint.ata.1.port="0x170"
>set hint.ata.1.irq="15"
>boot
>
>If it does work, then add the following lines to your /boot/device.hints
>file:
>
>hint.ata.0.at="isa"
>hint.ata.0.port="0x1F0"
>hint.ata.0.irq="14"
>hint.ata.1.at="isa"
>hint.ata.1.port="0x170"
>hint.ata.1.irq="15"
>
>Also, if that does work, then we should think about adding those lines
>to GENERIC.hints for Alpha.

Thanks, I'll try the hints tonight.  The ATA controller is built into the 
motherboard on the Cabriolet


--
In this world, truth can wait; she's used to it.

This is random quote 706 of a collection of 1255

Distance from the centre of the brewing universe:
[15200.8 km (8207.8 mi), 262.8 deg](Apparent) Rennerian

Public Key fingerprint = 6219 33BD A37B 368D 29F5  19FB 945D C4D7 1F66 D9C5


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?5.1.0.14.2.20021111112347.05180670>