Date: Sat, 10 Mar 2007 12:45:47 -0500 From: Mike Tancsa <mike@sentex.net> To: mjacob@freebsd.org Cc: freebsd-hardware@freebsd.org Subject: Re: MPT SAS1064 Message-ID: <200703101743.l2AHhaK5007440@lava.sentex.ca> In-Reply-To: <20070310085001.Q70411@ns1.feral.com> References: <200703091820.l29IKuwT001782@lava.sentex.ca> <20070309221943.I64099@ns1.feral.com> <200703101452.l2AEqdqq006832@lava.sentex.ca> <20070310085001.Q70411@ns1.feral.com>
next in thread | previous in thread | raw e-mail | index | archive | help
At 11:51 AM 3/10/2007, mjacob@freebsd.org wrote: >Do you know what the actual attached disk(s) are? Can you get into >the MPT BIOS and look at the RAID Properties tab if it exists? Hi, Yes, I just attached a couple of Segate SATA drives and configured the card to be a RAID1 mirror. ---Mike >>At 01:21 AM 3/10/2007, mjacob@freebsd.org wrote: >> >> >>>Haven't a clue- this doesn't appear to be the embedded mirroring >>>adapter- which is good because you're lucky if it works at all for >>>you. What's the actual underlying device? >> >>Hi, >> Not sure how to find that out ? I dont see anything in >> dmesg or pciconf other than what I included in the original email. >> >> ---Mike >> >> >>>>| LSI Logic MPT Setup Utility v6.04.00.00 (2005.08.29) | >>>>| Adapter List Global Properties | >>>>| Adapter PCI PCI PCI PCI FW Revision Status Boot | >>>>| Bus Dev Fnc Slot Order | >>>>| SAS1064 03 01 00 02 1.06.00.00-IR Enabled 0 | >>>>[tyan-1u]% dmesg | grep mpt >>>>mpt0: <LSILogic SAS/SATA Adapter> port 0xd800-0xd8ff mem >>>>0xdfefc000-0xdfefffff,0xdfee0000-0xdfeeffff irq 48 at device 1.0 on pci3 >>>>mpt0: [GIANT-LOCKED] >>>>mpt0: MPI Version=1.5.10.0 >>>>mpt0: mpt_cam_event: 0xb >>>>mpt0: Unhandled Event Notify Frame. Event 0xb (ACK not required). >>>>da0 at mpt0 bus 0 target 8 lun 0 >>>>[tyan-1u]% dmesg | grep da0 >>>>da0 at mpt0 bus 0 target 8 lun 0 >>>>da0: <LSILOGIC Logical Volume 3000> Fixed Direct Access SCSI-2 device >>>>da0: 300.000MB/s transfers, Tagged Queueing Enabled >>>>da0: 75340MB (154296320 512 byte sectors: 255H 63S/T 9604C) >>>>[tyan-1u]% >>>>mpt0@pci3:1:0: class=0x010000 card=0x30201000 chip=0x00501000 >>>>rev=0x02 hdr=0x00 >>>> vendor = 'LSI Logic (Was: Symbios Logic, NCR)' >>>> class = mass storage >>>> subclass = SCSI >>>> cap 01[50] = powerspec 2 supports D0 D1 D2 D3 current D0 >>>> cap 05[98] = MSI supports 1 message, 64 bit >>>> cap 07[68] = PCI-X 64-bit supports 133MHz, 2048 burst read, >>>> 16 split transactions >>>> cap 11[b0] = MSI-X supports 1 message in map 0x14 >>>> >>>>-------------------------------------------------------------------- >>>>Mike Tancsa, tel +1 519 651 3400 >>>>Sentex Communications, mike@sentex.net >>>>Providing Internet since 1994 www.sentex.net >>>>Cambridge, Ontario Canada www.sentex.net/mike >>
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200703101743.l2AHhaK5007440>