Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 1 May 2020 11:39:05 +0200
From:      Morten Bo Johansen <listmail@mbjnet.dk>
To:        freebsd-questions@freebsd.org
Subject:   Mounting SD-card in my camera
Message-ID:  <slrnranrhp.1aa.listmail@asmtp.unoeuro.com>

Next in thread | Raw E-Mail | Index | Archive | Help
Hi

I am still rather new to FreeBDS so please bear with me ...but
I have a problem mounting the file system on the SD-card of my
camera via the USB cable . I am sure it must be a vfat file
system. When I plug in the cable and turn on the camera, a
/dev/da0 device node is created and dmesg shows:

     ugen2.2: <Panasonic DMC-FZ200> at usbus2
     umass0 on uhub5
     umass0: <Panasonic DMC-FZ200, class 0/0, rev 2.00/1.00, addr 2>
     on usbus2
     umass0:  SCSI over Bulk-Only; quirks = 0xc100
     umass0:3:0: Attached to scbus3
     pass2 at umass-sim0 bus 0 scbus3 target 0 lun 0
     pass2: <MATSHITA DMC-FZ200 0100> Removable Direct Access SPC-3
     SCSI device
     pass2: Serial Number 000000000000000000GX1R07230881
     pass2: 40.000MB/s transfers
     GEOM: new disk da0
     da0 at umass-sim0 bus 0 scbus3 target 0 lun 0
     da0: <MATSHITA DMC-FZ200 0100> Removable Direct Access SPC-3
     SCSI device
     da0: Serial Number 000000000000000000GX1R07230881
     da0: 40.000MB/s transfers
     da0: 15298671411200MB (535734837315633153 512 byte sectors)
     da0: quirks=0x2<NO_6_BYTE>
     da0: Delete methods: <NONE(*),ZERO>
     da0: Write Protected

However, the output from

      blkid /dev/da0
      
shows nothing (running it with sudo makes no difference)      

The output from sudo camcontrol devlist:
      
    <MATSHITA DVD/CDRW UJDA780 CB01>   at scbus0 target 0 lun 0 (cd0,pass0)
    <CT240BX500SSD1 M6CR013>           at scbus1 target 0 lun 0 (pass1,ada0)
    <MATSHITA DMC-FZ200 0100>          at scbus3 target 0 lun 0 (da0,pass2)

My camera is listed in the last line 

I have installed all the fusefs modules, automountd is running.
I have enabled automount and autofs in rc.conf. I have
vfs.usermount=1 in sysctl.conf

I can access my usb backup disk, which has an ext4 file system
on it and mount it with lklfuse. I notice that when I plug in
my backup disk a subnode /dev/da0s1 is created and I use that
node to access the backup disk,. This node is not created when
I plug in my camera.

I simply cannot contact the camera at all. Anyone who could
help me?

 Thanks,
 Morten




Want to link to this message? Use this URL: <http://docs.FreeBSD.org/cgi/mid.cgi?slrnranrhp.1aa.listmail>