Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 28 Nov 2002 13:20:52 -0400 (AST)
From:      "Marc G. Fournier" <scrappy@hub.org>
To:        "Justin T. Gibbs" <gibbs@scsiguy.com>
Cc:        freebsd-stable@FreeBSD.ORG, <kerri@acadiau.ca>
Subject:   Re: Overlooking something, but what?   (missing 39160 controller)
Message-ID:  <20021128131925.M16724-100000@hub.org>
In-Reply-To: <2797960000.1038502434@aslan.scsiguy.com>

next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, 28 Nov 2002, Justin T. Gibbs wrote:

> > Server is an IBM xSeries 360 ... only slot'd card is the 39160, everything
> > else is onboard ... the card is in the same 64bit slot that it was in when
> > it worked originally, but I have tested other slots and the same results
> > ...
>
> Most likely FreeBSD is not enumerating the PCI bus that the card is attached
> to.  Those that have tweaked the chipset drivers may be able to point you
> in the right direction.  You should tell the list what chipset FreeBSD
> finds on the system.

'K, you'll have to help me out here ... not sure what chipset you are
looking for, but my dmesg shows:

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.6-STABLE #1: Thu Nov 28 10:34:33 AST 2002
    root@demeter.acadiau.ca:/usr/obj/usr/src/sys/nemesis
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium 4 (1500.26-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf11  Stepping = 1
  Features=0x3febfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,<b28>,ACC>
real memory  = 3742273536 (3654564K bytes)
avail memory = 3645231104 (3559796K bytes)
APIC_IO: MP table broken: 8259->APIC entry missing!
Programming 51 pins in IOAPIC #0
IOAPIC #0 intpin 2 -> irq 0
IOAPIC #0 intpin 36 -> irq 9
FreeBSD/SMP: Multiprocessor motherboard
 cpu0 (BSP): apic id:  0, version: 0x00050014, at 0xfee00000
 cpu1 (AP):  apic id:  4, version: 0x00050014, at 0xfee00000
 io0 (APIC): apic id: 14, version: 0x00320011, at 0xfeca0000
Preloaded elf kernel "kernel" at 0xc02b3000.
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
IOAPIC #0 intpin 17 -> irq 2
IOAPIC #0 intpin 42 -> irq 3
IOAPIC #0 intpin 41 -> irq 5
IOAPIC #0 intpin 16 -> irq 7
pci0: <PCI bus> on pcib0
pci0: <S3 Savage 4 graphics accelerator> at 1.0
chip1: <PCI to Other bridge (vendor=1014 device=010f)> port 0x1800-0x187f mem 0xfbc00000-0xfbdfffff irq 2 at device 2.0 on pci0
pci0: <unknown card> (vendor=0x8086, dev=0x1229) at 3.0 irq 3
ahc0: <Adaptec aic7892 Ultra160 SCSI adapter> port 0x1900-0x19ff mem 0xfbf7e000-0xfbf7efff irq 5 at device 4.0 on pci0
aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
pci0: <unknown card> (vendor=0x1014, dev=0x0246) at 6.0
isab0: <ServerWorks IB6566 PCI to ISA bridge> at device 15.0 on pci0
isa0: <ISA bus> on isab0
pci0: <Unknown PCI ATA controller> at 15.1
pci0: <OHCI USB controller> at 15.2 irq 7
orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <2 virtual consoles, flags=0x200>
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
APIC_IO: Testing 8254 interrupt delivery
APIC_IO: routing 8254 via IOAPIC #0 intpin 2
Waiting 2 seconds for SCSI devices to settle
SMP: AP CPU #1 Launched!
pass0 at ahc0 bus 0 target 9 lun 0
pass0: <IBM YGHv3 S2 0> Fixed Processor SCSI-2 device
pass0: 3.300MB/s transfers
da0 at ahc0 bus 0 target 12 lun 0
da0: <IBM-ESXS ST336605LC    !# B243> Fixed Direct Access SCSI-3 device
da0: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enabled
da0: 34715MB (71096640 512 byte sectors: 255H 63S/T 4425C)
da1 at ahc0 bus 0 target 13 lun 0
da1: <IBM-ESXS ST336605LC    !# B243> Fixed Direct Access SCSI-3 device
da1: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enabled
da1: 34715MB (71096640 512 byte sectors: 255H 63S/T 4425C)
Mounting root from ufs:/dev/da0s1a
WARNING: / was not properly dismounted
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0x1880-0x18bf mem 0xfbe00000-0xfbefffff,0xfbf7f000-0xfbf7ffff irq 3 at device 3.0 on pci0
fxp0: Disabling dynamic standby mode in EEPROM
fxp0: New EEPROM ID: 0x48e0
fxp0: EEPROM checksum @ 0x3f: 0x4203 -> 0x4203
fxp0: Ethernet address 00:02:55:ac:12:d5
inphy0: <i82555 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20021128131925.M16724-100000>